Shoprider GK9 manual Maintenance, Troubleshooting Guide

Page 15

MAINTENANCE

Tires

Since your tires are flat free tires, there is no need to ever worry about tire air pressure.

General Maintenance and Lubrication

Inspection for loose wheel bolts, seat and arm tightening bolts, and other nuts and bolts is recommended on a regular basis.

Most lubricated components on the Start 8 Portable scooter are designed to be maintenance free and are sealed. Therefore lubrication is not required for these components. However, the driving axles and seat post should always have a very light coat of multipurpose grease.

DO NOT USE TOO MUCH GREASE!

Drips may stain or damage carpets, furnishings, etc.

It is recommended that the driving axles (inside the drive wheel assembly) be checked and cleaned occasionally for hair and debris build-up, which will hinder the performance of the unit.

Check the batteries on a regular basis. For extended battery life, it is highly recommended that the batteries be fully charged after each use. If the batteries are weak, severely discharged or old, a variety of problems may occur with the unit including charging problems, reduced speed, loss of range, and others. Please contact your local Shoprider® provider for battery replacement.

TROUBLESHOOTING GUIDE

Circuit Breaker (Reset Button)

Your scooter is fitted with the latest in electronic controls that are programmed to protect the electrical system from abnormal overloads. Provided for extra protection is a circuit breaker, located on the side of the battery pack. Should there be a situation where your scooter stops for no apparent reason, please check that the circuit breaker has not popped.

NOTE: To preserve battery charge, your scooter may go into sleep mode after being idle for a few minutes. To reset, turn the key off and back on again.

Check List

If your scooter fails to operate, please check the following:

Unit is switched on.

Drive/Freewheel mechanism is in the drive position.

All plugs and connectors are clean and firmly connected. Push reset button.

Battery level shows full charge.

If the free wheel device has been operated with the scooter switched on, then the scooter will not operate until the ignition key has been switched off and then on again.

Please consult your dealer if your scooter does not run after checking these points.

7/8/2009SE

15

Image 15
Contents Start Table of Contents Introduction Smart Feature Guide FigSafety Advice Scooter Electromagnetic Interference EMI EMI Warning2009SE Seat Removal Fig AdjustmentsTiller Angle Adjustment Fig Folding the Tiller FigSerial Number Fig Seat Height Adjustment FigArmrest Width Adjustments Fig Armrest Adjustments FigScooter Tiller Controls FIG DRIVE/FREEWHEEL Operation FIG Anti-tip wheelsScooter serial number Starting to Drive Your Scooter Grass and Gravel Extra Guidelines in the Control of Your ScooterRamps Safe Climbing AngleTransport / Storage Start 8 8 DisassemblyBatteries and Battery Charging Battery ChargerCharging Troubleshooting Guide MaintenanceUnit Specifications Technical SpecificationsQuarterly Inspection GK9Y M / D / Y M / D / Y M / D / Y M / D / Y M / D / Y 2009SE Warranty