Pride Mobility SC52 B a T T E R I E S a N D C H a R G I N G, Reading Your Battery Voltage

Page 23

V I . B A T T E R I E S A N D C H A R G I N G

Your scooter requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free. They are recharged by an off-board battery charging system.

νFully charge your scooter’s batteries prior to using it for the first time.

νKeep the batteries fully charged to keep your scooter running smoothly.

READING YOUR BATTERY VOLTAGE

The battery condition meter on the tiller console indicates the approximate strength of your batteries using a color code. Green indicates fully charged batteries, yellow a draining charge, and red indicates that an immediate re- charge is necessary. See figure 9. To ensure the highest accuracy, the battery condition meter should be checked while operating your scooter at full speed on a dry, level surface.

CHARGING YOUR BATTERIES

Figure 9. Battery Condition Meter

 

PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger directly into a properly wired standard wall outlet.

PROHIBITED! Removal of the grounding prong can create an electrical hazard. If necessary, properly install an approved 3-pronged adapter to an electrical outlet having 2- pronged plug access. Failure to heed could result in personal injury and/or property damage.

WARNING! Ensure that both ends of the charger power cord are clean and dry before plugging the charger power cord into the off-board battery charger port or the wall socket.

Charging the batteries on the scooter:

1.Position your scooter close to a standard wall outlet.

2.Remove the key from the key switch.

3.Make certain that the manual freewheel lever is in the drive position.

4.Plug the 3-pin charger power cord (see figure 10) into the battery charging port. See figure 8.

5.Extend the charger power cord and plug it into the wall outlet.

7.It is recommended that you charge your batteries for 8 to 14 hours.

8.When the batteries are fully charged, unplug the charger power cord from the wall outlet and then from the charger power cord receptacle.

9.Replace the charger power cord receptacle cover.

PLUGS INTO STANDARD WALL OUTLET

NOTE: There is a charger inhibit function on your

CHARGE POWER

scooter. The scooter will not run and the battery

 

condition meter will not operate while the batteries

 

are charging.

 

 

PLUGS INTO OFF-BOARD

 

BATTERY CHARGER PORT

 

Figure 10. Off-Board Battery Charger

Sonic

www.pridemobility.com

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Ultimate In Style & Performance F E T Y G U I D E L I N E S N T E N T S Information Exchange SafetyN T R O D U C T I O N PURCHASER’S AgreementS a F E T Y Product Safety SymbolsS a F E T Y Removable Parts GeneralModifications Incline Information PRE-RIDE Safety CheckWeight Limitations Tire InflationMaximum Recommended Incline Angles Braking Information Cornering InformationPublic Streets and Roadways Outdoor Driving SurfacesDoors Inclement Weather PrecautionsFreewheel Mode Stairs and EscalatorsBatteries Battery Disposal and RecyclingElevators LIFT/ELEVATION ProductsReaching and Bending Motor Vehicle TransportAlcohol Positioning BeltsPrescription DRUGS/PHYSICAL Limitations EMI/RFI Warnings EMI/RFI Frequently Asked Questions FaqsWhere do radio waves come from? I . E M I / R FWhat should I do if my mobility vehicle moves unexpectedly? What is the FDA doing about the problem?Are all electric mobility vehicles susceptible to EMI/RFI? Sonic Dimensions Specification SHeaviest Piece When Disassembled Tiller Console O U R S C O O T E RRear Section Horn ButtonsAnti-Tip Wheels Battery Charging ComponentsCharging the batteries on the scooter Reading Your Battery VoltageB a T T E R I E S a N D C H a R G I N G Charging Your BatteriesCharging the Batteries OFF the Scooter Frequently Asked Questions Faqs How can I get maximum range or distance per charge? What type and size of battery should I use?Why do my new batteries seem weak? Battery Removal Battery ReplacementGetting Onto Your Scooter PRE-RIDE Adjustments and ChecksI . O P E R a T I O N Before Getting Onto Your ScooterGetting OFF of Your Scooter Power Down Timer FeatureSeat Rotation Tiller Angle AdjustmentSeat Height Adjustment I I . C O M F O R T a D J U S T M E N T SBoth the seat frame and armrest frame Armrest Width AdjustmentD I S a S S E M B LY a N D a S S E M B LY DisassemblyToggle Latch Release Assembly What if the motor runs but my scooter does not move? A S I C TroubleshootingDiagnostic Beep Codes What if all the systems on my scooter seem to be dead?Working Fuse What if the main circuit breaker trips repeatedly?C a R E a N D M a I N T E N a N C E I . W a R R a N T Y Implied Warranties Service Checks and Warranty ServiceSusquehanna Ave. Exeter, PA 18643

SC52 specifications

The Pride Mobility SC52, also known as the Go-Go Elite Traveler 4-Wheel scooter, is a popular choice among individuals seeking mobility solutions that combine ease of use, maneuverability, and comfort. This scooter is designed for both indoor and outdoor use, making it versatile for various lifestyles and environments.

One of the main features of the SC52 is its 4-wheel design, which enhances stability and provides a smooth ride over various terrains. With a top speed of 4.5 miles per hour and a driving range of up to 12 miles on a single charge, users can navigate both urban streets and suburban sidewalks with confidence. The dual motor design offers exceptional acceleration while remaining energy efficient, allowing users to make the most out of each charge.

The SC52 is equipped with ergonomically designed, comfortable seating that includes flip-back arms to facilitate easy transfer in and out of the scooter. The seat height is adjustable, ensuring that users can find their optimal position for driving. Moreover, the unit features a delta tiller, which requires minimal strength to operate, making it accessible for users with varying levels of dexterity.

Another noteworthy characteristic of the SC52 is its lightweight, portable design. The scooter can be easily disassembled into five lightweight sections, making it ideal for transport in cars, buses, or trains. Each section is crafted to ensure maximum portability without compromising on durability.

In terms of technology, the Pride Mobility SC52 includes an advanced battery management system. This feature not only extends the life of the batteries but also provides users with information about battery status through an easy-to-read LED display. Safety features are also a priority in the SC52, which is equipped with anti-tip wheels, powerful LED headlights for visibility in low-light conditions, and a secure braking system.

With a variety of color options and accessories, such as storage baskets and weather protection, the Pride Mobility SC52 caters to personal preferences and lifestyle needs, making it a standout choice in the mobility scooter market. Whether for daily errands or leisurely outings, the SC52 offers an unparalleled combination of reliability, comfort, and style.
Top Page Image Contents