Setup
1. Firmly press the thumb tab and pivot the
upright up until it locks in a nearly verti- cal position.
2.Insert the handles into the stem until the
lock pins are visible in the holes in the stern.
3.Open the
lock pin on the stem and slide the stem up until the lock pin is visible in one of the three holes in the upright. When the stem is at the desired height, close the
Before using the scooter, make sure that the scooter is set up as described and that all parts are securely tightened.
The decal shown at the right has been - placed on the scooter. If the decal is miss- ing, or if it is not legible, please call our
Customer Service Department
order a free replacement decal. Apply the
replacement decal to the location shown.
To prevent serious Injury:
•Read, understand and follow all war-
nlngs and Instruc- tions on the unit
and in the manual,
•Always wear pro- tecllve equipment Including helmet, kneapads, wrlst guards, and elbow pads.
•Keep away from cars, streets or areas that enter vehicle traffic mutes.
•Never ride when towed behind bi-
cycles, motorcy- cles, or vehicles
•Do not ride at night or In poor visibility
Hand
Right Side
Storage
1.
down into the upright. Close the quick- release lever.
2
3
Depress the lock pins and remove the |
| |
handles | from the stem. Press the handles |
|
into the | storage clip on the upright. |
|
Pull the | thumb tab and pivot the upright |
|
down until it locks in the horizontal posi- | Hand Brake, Carry Strap, and Cable not shown. | |
tion. |
|
|