V I . D I S A S S E M B L Y
Seat Removal
You may wish to remove the seat for transportation. If you have a Synergy Seating System, please refer to the information pro- vided with your seating system.
To remove the seat:
1.Turn off the power to the controller.
2.Make sure your power chair is not in freewheel mode. See III. “Your Power Chair.”
3.Unplug the controller connector from the electronics tray.
4.Flip up the seat latch safety. See figure 24.
5.Squeeze the seat latch and release the seat from the front trapeze bar.
6.Slide the seat forward and remove it from the power base.
To remove a power seat:
1.Turn off the power to the controller.
2.Unplug the power seat cable from the electronics tray.
3.Unplug the controller
4.Unplug the power seat connector.
5.Release the seat by moving the seat release lever backward.
6.Lift up the power seat plate.
7.Lift the seat off of the actuator.
Foot Frame Removal
The foot frame helps protect the power chair components from the environment. See figure 25. You must remove the foot frame in order to change the batteries and check the cable connections.
To remove the foot frame:
1.Turn off the power to the controller
2.Make sure your power chair is not in freewheel mode. See III. “Your Power Chair.”
3.Locate the ball detent pin at the base of the footrest bracket and remove. See figure 17.
4.Lift the foot frame straight up approximately 2 inches and pull toward you.
Figure 24. Seat Safety Latch
BALL |
DETENT PIN |
Figure 25. Removing the Foot Rest Frame
28 | www.pridemobility.com | Jazzy 1122 |