Schwinn Motor Scooters 50CG06SV, 50CG06RD manual Breaking In the Scooter, Riding the Scooter

Page 12

Breaking In the Scooter

For the first 100 miles (160 kilometers) it is recommended that you kick start the scooter, or use the kick starter to “prime” the engine (force fuel into the carburetor) prior to using the electric starter. This preserves battery life and reduces wear to the electric starter during the break-in period.

ALWAYS allow the engine to warm up for 2 to 3 minutes before driving.

Do not drive the scooter at a constant speed for long periods of time during the break-in period. Avoid overheating the engine.

Riding the Scooter

ENTERING ROADWAYS

Apply the turn signal if needed.

Make sure there is no oncoming traffic. ALWAYS be aware of other vehicles on public roads. Many accidents are caused when drivers of cars do not see scooters who share the road.

Release the brake and gradually advance the throttle for smooth acceleration.

ACCELERATION AND DECELERATION

Adjust speed by twisting the throttle. Twist the throttle toward you to accelerate. Twist the throttle away from you to decelerate. NOTE: Your new scooter has an automatic transmission, so there is no clutch and no need to shift gears.

ALWAYS allow the engine to warm up thoroughly before hard acceleration, or damage to the engine could occur.

BRAKING

WARNING

ALWAYS apply the front and rear brakes simultaneously to slow down or come to a stop.

BE CAUTIOUS when using the front brake. Loss of front wheel traction can make both steering and braking ineffective. Using the front brake on loose gravel or wet road conditions can result in loss of traction.

DO NOT continually engage the brakes for an extended period of time. This causes excessive wear and can overheat the brakes, causing brake failure which could result in serious injury or death.

In wet driving conditions, be aware that normal stopping distances are increased.

PARKING

NOTE: Always park on smooth, level ground.

Turn the ignition key to the OFF position. Remove the key.

Move the engine stop switch to the OFF position.

Dismount the scooter and engage the center stand.

DO NOT park on a slope or on soft surfaces. The scooter could tip over.

DO NOT park near flammable materials.

Engage the steering lock to prevent theft (see instructions on page 6).

10

Image 12
Contents Gas-powered Scooter Model 50CG06RD and 50CG06SV Table of Contents Specifications Safety PrecautionsIntroduction Vehicle RecordSafety Precautions Wear EYE and Face Protection Wear Protective ClothingStay Visible on the Road Features ControlsInstrumentation Description of Features KEY, Ignition SWITCH, Steering Lock and Seat LockEngine Stop Switch and Starter Button Right Handlebar Headlight and Turn Signal Left HandlebarVIN Badge and Access Plate Throttle Right Handlebar GripHelmet Storage Hook BrakesBefore Every Ride Starting the ScooterAutomatic Choke Kick Start Electric StartBreaking In the Scooter Riding the ScooterRoutine Care and Maintenance Tire MaintenanceRefueling Rear Drum Brake Adjustment Check Rear Drum Brake Shoe WearCheck Front Disc Brake Fluid Level Check Front Disc Brake PAD WearAdding Engine OIL Changing the Engine OILAdding Transmission OIL Changing Transmission OILBattery Maintenance Inspecting the Battery TerminalsReplacing the Battery Battery DisposalCleaning or Replacing the AIR Filter Replacing the FuseReplacing the Spark Plug Troubleshooting Reporting Safety DefectsCleaning Professional Maintenance Schedule Limited Warranty Emissions Performance WarrantyScooter Noise Regulation Exhaust system Intake System