V . C O M F O R T A D J U S T M E N T S
10.Loosen the shroud fasteners and remove the front shroud from the power base.
11.Remove the hardware from the front trapeze bar.
12.Raise or lower the front trapeze bar to the desired position.
NOTE: To change the angle, set either the front or rear trapeze bar higher or lower than the other.
13.Reinstall the hardware into the front trapeze bar.
14.Place the seat back onto the trapeze bars and flip down the seat latch safety.
15.Reinstall the front shroud.
16.Reconnect the controller.
17.Close the battery door and secure the battery door latches if necessary.
Seat Position
You can move the seat forward or rearward by changing the extrusion mounting position.
To change the position:
1.Turn off the power to the controller.
2.Make sure the power chair is in drive mode.
3.Release the battery door latches and open the battery door if necessary.
4.Disconnect the controller connector(s) from the power base. See figure 6.
5.Remove the seat from the power base.
6.Remove both extrusions from the bottom of the seat.
7.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or backward. See figure 16.
8.Fasten the extrusions back onto the bottom of the seat.
9.Reinstall the seat.
10.Reconnect the controller to the power base. See figure 6.
11.Close the battery door and secure the latches if necessary.
12.Secure the controller harness to the armrest with wire ties. See figure 14.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base.
To adjust the recline angle:
1.Pull up on the seatback release lever.
2.Lean forward or backwards to the desired position.
3.Release the lever.
SEAT MOUNTING HOLES |
Figure 17. Seat Position Adjustment
24 | www.pridemobility.com | Quantum |