Seat Height Adjustment (Fig 7)
Remove seat as described (fig 6). Remove battery pack (refer to disassembly section). Using two 13mm wrenches, remove locking bolt and nut. Adjust seat post up or down to desired position. The seat height can be adjusted to five different positions by inserting the locking bolt in the desired hole. Replace washer and nut and tighten. Replace battery pack and seat.
Serial Number (Fig 7)
Serial number is located on the seat post. It is on a white sticker with a barcode. The serial number is 13 alphanumerical digits beginning with a 1.
Seat
Post
Adjustment
Holes
Scooter
Serial
Number
Locking
Bolt
Armrest Width Adjustments (Fig 8)
On the underside back of the seat there are two arm rest hand knobs, one on each side. Turn hand knobs counterclockwise to loosen. Loosening the arm rest hand knob allows the armrest width to be adjusted or arm rest to be removed. Once the desired positions of the arm rests are set, tighten the hand knobs by turning clockwise to lock the arm rests into place.
Armrest Adjustments (Fig 8)
The arm rests are hinged and can be pulled up and out of the way for sideways transfer. Pull arm rest up and back.
12/8/20069
Figure 7
Pull Arm Up
Arm Rest
Hand Knob
Figure 8