Shoprider ISO9001, ISO13485, ISO14001 manual Batteries & Battery Charging

Page 22

GMP

ISO9001

ISO14001

ISO13485

CERTIFIED

BATTERIES & BATTERY CHARGING

BATTERIES

The Powerchair is supplied with 2 x 33/34/36 Ah gel, sealed lead acid, maintenance free batteries. These are fitted under the seat in the center of the Powerchair. For easy handling, Velcro or plastic carrying straps are provided to assist in fitting or removal. The duration of the batteries can be affected by temperature, terrain and weight of the user. The Battery Gauge is a guide on the remaining charge in the batteries.

The active user will need to charge the batteries after using approximately more than 30% of battery capacity. As an inactive user, only using from once a week to every other day, the recharge point would be at 50% of discharge.

If only using for short distance each day, it is advisable to charge at the end of each week. The state of battery capacity could be referred as Fig.18.

Red Bottom

Amber Middle

Green Top

3 Bars

4 Bars

3 Bars

Flashing. Danger, you

From 30% - 50%

Full battery charge.

must stop and recharge

discharge.

 

the batteries. Failure to

Batteries will

 

do so may result in

need charging.

 

damage of batteries.

 

 

 

Fig. 18

 

Batteries should be kept fully charged at all times. They must not be left in a discharged state if not using the unit for some time. The batteries should be checked once a month and recharged as needed.

BATTERY CHARGING FOR STREAMER-888WAB & WIZZ-888WNL (UNITS EQUIPPED WITH ON-BOARD CHARGER)

The batteries supplied with the Powerchair are specially designed and require an automatic battery charger. The battery charger is fitted with an electronic switch that terminates the charge when the batteries are fully charged.

WARNING! Only use the original manufacturer approved charger.

On-Board battery charger is set beneath the shroud as Fig.19. Charging procedures are as the following:

~21~

Image 22
Contents Medical Power Wheelchair Contents Introduction Feature GuideWizz 888WNL Streamer 888WB/888WSB Streamer 888WABJEETSTREAM-M 888WAM JETSTREAM-L 888WALEMI Warning Electromagnetic Interference EMI from Radio Wave SourcesPowerchair Electromagnetic Interference EMI Safety Instructions ~8~ Joystick Controller Chassis Shroud of Wizz 888WNL ~10~ Chassis Shroud of JETSTREAM-L/M 888WAL/888WAM Preparation for USE Programmable Controller Angle Adjustment ProceduresLength HeightFootrest Adjustments JETSTREAM-L/M888-WAL/WAM Safety Belt and Fastening Strap Setting Operation Instructions Getting Ready to Know the Joystick Controller VSIEngaged / Disengaged Mode Getting Ready to DriveComponents for Streamer 888WB/WAB/WSB Disassembly & Assembly InstructionsComponents for Wizz 888WNL Components for Jetstream -L/M 888WAL/WAMDisassembly Procedures Batteries & Battery Charging Batteries~22~ ~23~ Trouble Shooting Battery Gauge Possible Fault~25~ Specification TE-888WNL TE-888WAL TE-WAMQuarterly Inspection Disclaimer