V . A S S E M B L Y
SEAT ANGLE ADJUSTMENT
The seatback can be adjusted at four different angles, depending on user preference. A 90º, 102º, 105º, or 107 º angle can be set.
To adjust the seat angle:
1.Use a hex key and a
2.Set at desired angle.
3.Reinstall the bolt and tighten.
| FRONT |
|
|
| SEAT | REAR SEAT TOWERS | |
| TOWERS | ||
SEAT INSTALLATION (SEAT WITH |
|
| |
|
|
| |
Thestandardseatinstallationmethodincorporatestheseatframe(H- |
|
|
|
frame) and four (4) adjustable seatposts located on the power base. |
|
|
|
|
|
|
To install the seat:
1. Set the seat on the rear seat towers. See figure 10.
2. Push the seat back and down until the latches engage on the front seat towers. See figure 10.
3. | Plug the controller cable into the connector on the utility tray. |
|
| |
| See figure 11. |
|
| |
4. | Plug the power seat switch cable (if so equipped) into the |
|
| |
| connector on the utility tray. |
|
| |
5. | Secure the controller cable to the armrest receiver with one |
|
| |
| or more wire ties. |
|
| |
6. | Route the cable to ensure that the cable cannot be pinched in | Figure 10. Seat Towers | ||
| the seat hinge. |
|
| |
JOYSTICK INSTALLATION | CONTROLLER CABLE | |||
Depending on the various configurations and options you have | ||||
|
| |||
|
| |||
chosen for your Jazzy, it may have been shipped without the joy- |
|
| ||
|
| |||
stick installed in the armrest. |
|
|
To install the joystick:
1.Use a
2.Slide the joystick mounting bracket into or out of the armrest to the desired position.
3.Retighten the setscrew.
Figure 11. Controller Cable Connection
16 | Jazzy 11202000 |