Pride Mobility SC155, SC151 owner manual Assembly, Frame Handle

Page 33

I X . D I S A S S E M B LY A N D A S S E M B LY

UPPER SEAT POST

FRAME LOCK UP

Figure 17. Frame Handle

Figure 18. Frame Separation

ASSEMBLY

1.Push down on the manual freewheel lever. See V. “Your Rally.” Putting your scooter in drive mode may make it easier for you to maneuver the rear section because the drive wheels are stabilized.

2.Position the front and rear sections of your scooter as shown in figure 18.

3.Gently pull up on the upper seat post so the front of the rear section pivots up.

4.Using the frame handle, lift the front section and align the lower slots on the rear of the front section with the corresponding lower pegs on the front of the rear section. Pivot the rear section forward until it locks in place with a “click.” See figure 17.

5.Raise the tiller to the upright position by turning the tiller adjustment lever counterclockwise until it is loose. Press the release buttons and raise the tiller to the desired position. Tighten the tiller adjustment lever.

6.Connect the large, white, 9-pin front-to-rear connector located on the harness coming out of the scooter’s front section to the connector’s mating socket found near the front of the scooter’s rear section.

7.Place the batteries in the battery wells and strap them in place.

8.Connect the 2-pin battery harnesses into the mating harnesses that extend from the electronic controller as- sembly.

9.Gently place the rear shroud over the seat pedestal and slide it down into position. The reusable fasteners hold it in place.

10.Carefully lift the seat and slide the post (on the bottom of the seat frame) into the seat pedestal.

11.Rotate the seat until it locks into place to complete the assembly of your scooter.

Rally/RevF/September 03

www.pridemobility.com

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Ultimate In Style & Performance F E T Y G U I D E L I N E S N T E N T S N T R O D U C T I O N SafetyExpressed Agreement of Indemnification Information ExchangePride Owners Club General S a F E T YModifications Removable Parts Electromagnetic FieldsWeight Limitations PRE-RIDE Safety CheckTire Inflation Incline InformationMaximum Recommended Normal Driving Position Cornering InformationOutdoor Driving Surfaces Stationary Obstacles STEPS, CURBS, ETCBraking Information S a F E T Y Doors Stairs and EscalatorsElevators LIFT/ELEVATION ProductsBattery Disposal and Recycling Preventing Unintended Movement Motor Vehicle TransportGetting Onto and OFF of Your Scooter Reaching and Bending Positioning BeltsPrescription DRUGS/PHYSICAL Limitations AlcoholEMI/RFI Frequently Asked Questions Faqs I . E M I / R FEMI/RFI Warnings Are all electric mobility vehicles susceptible to EMI/RFI? Rally Dimensions Specification SSpecification S O U R R a L L Y Control Console AssemblyKey Switch Rear Section Onboard Battery ChargerBattery Charger Fuse Motor/Transaxle Assembly Reading Your Battery Voltage B AT T E R I E S a N D C H a R G I N GCharging Your Batteries How does the charger work? Frequently Asked Questions FaqsHow can I get maximum range or distance per charge? How should I store my scooter and its batteries? I . O P E R a T I O N PRE-RIDE Adjustments and ChecksBefore Getting on Your Scooter Getting Onto Your ScooterGetting OFF of Your Scooter Power Down Timer FeatureTiller Angle Adjustment Seat Height AdjustmentI I . C O M F O R T a D J U S T M E N T S FRONT-TO-BACK Seat Adjustment Armrest Width AdjustmentSeat Rotation D I S a S S E M B LY a N D a S S E M B LY DisassemblyFrame Handle AssemblyP T I O N a L a C C E S S O R I E S Optional AccessoriesProblem Possible Solutions TroubleshootingI . C a R E a N D M a I N T E N a N C E Storing Your Scooter CONSOLE, CHARGER, and Rear ElectronicsTHREE-YEAR Warranty Exceptions THREE-YEAR Limited WarrantyONE-YEAR Limited Warranty Warranty ExclusionsSusquehanna Ave. Exeter, PA 18643
Top Page Image Contents