Onboard Battery Installation

I I I . I N S T A L L A T I O N

2.Conceal the harness behind or under the interior panels of the vehicle (there should be existing holes). Be certain that the harness is protected with a rubber grommet when passing it through the metal panels and into the engine compartment.

3.Inside the engine compartment, secure the harness to the firewall and the inner fender with plastic wire ties. Use care not to cause abrasions to the wiring harness. It is important to secure the wiring harness at various points along its run of the vehicle.

WARNING! Do not cut or shorten the wiring harness. If the harness is too long, coil the excess wire and secure it with plastic wire ties.

4.Connect the red wire to the positive (+) terminal and the black (grounding) wire to the negative (-) terminal of the vehicle battery.

WARNING! Before operating the lift, inspect the wiring harness for proper routing and grounding. Improper routing can cause damage to the harness, and improper grounding can cause damage to the electrical system.

The optional onboard battery is designed for easy installation as it does not require any wires to be routed through or under the vehicle.

Follow these steps to install the onboard battery:

1.Align the mounting holes in the battery case bracket with those in the accessory bracket located under the key switch tube. See figure 7.

2.Secure the battery case to the accessory bracket with the supplied hardware. See figure 7.

3.Insert the onboard battery into the battery case, making sure that the connector on the bottom of the battery aligns and fully connects with the mating connector inside the battery case.

4.Plug the battery cord on the bottom of the battery case into the mating connector running from the motor. See figure 7.

Automatic Lock-down Arm Installation

The automatic lock-down arm is a safety feature designed to secure scooters to the lift platform during vehicle transport. The automatic lock-down arm will come fully assembled. In order to secure it to the frame, align the lock-down arm bracket with the holes at the back of the lift frame under the tilt bar and install the supplied hardware to lock the assembly in place. See figure 8.

ACCESSORY BRACKET

BATTERY CASE

BRACKET

Figure 7. Onboard Battery Installation

LOCK-DOWN ARM

Figure 8. Automatic Lock-down Arm Installation

Exterior Lift System