Panasonic CZ-RD515U service manual Approximately 4 inches 100 mm, then feed the wire harness

(7)Feed the wire harness that was included in the wired remote controller package into the right lower rear of the unit and route it to the component box. (Fig. 4a)

‡When feeding the wire harness through the opening, be careful of the motor cable and be sure to feed the wire harness and motor cable together through the opening. (Fig. 4b)

‡Be careful not to damage the wire harness when installing the conduit during unit installation work.

Motor cable

Component box

Wire harness

Opening

Wire harness

Fig. 4b

Fig. 4a

Connector 3

(8) Cut the wire tube that was included in the kit package to a length

Connector 3

(4P)

(4P)

of approximately 4 inches (100 mm), then feed the wire harness

through it. Then connect Connector 3 (Fig. 3a) to the wire harness

connector (4P). (Fig. 4c)

(9) Take the wires (Fig. 3a) and use a wire clamp to bind together the

wire for the noise filter and the wire for the thermistor (Fig. 5a). Then

position them so that the noise filter is contained within the space of

the component box. (Fig. 5b)

Connector (4P)

Wire harness

Wire tube Connector (4P)

Fig. 4c

Noise filter		Wire tube
Clamp	Component box	Clamp
		Clamping strap
Thermistor		Screw
		Wire harness
Fig. 5a	Fig. 5b	Fig. 6a

(10)Pass the wire tube through the clamping strap, and temporarily fasten in place with the screw. Next, use a clamp and bind the wires together immediately above the clamping strap, and fasten in place with the screw in order to prevent pulling on the wire harness. (Fig. 6a)

‡Install the wire tube so that the wires cannot be damaged by the edge of the metal plate. (Fig. 6a)

‡When re-installing the grille, confirm that there is no slack in the wire harness wires.

(11)Tighten the 4 screws to install the component box, taking care not to pinch any of the wires, then install the top cover. (Fig. 6b)

(12) Route the wire harness

Wire harness

Air intake grille

out through the small cut-out located at the bottom right side of the indoor unit frame. (Fig. 7a)

Self-diagnostic label

(13) Apply the label that was included in the package at a location close to the self-diagnostic label applied to the air intake grille. (Fig. 7b)

<Completion drawing >

Fig. 6b

Label		(14) Refer to the Installation Instructions
		that were included in the outdoor
Cut-out		unit package and re-install the
Fig. 7a	Fig. 7b	grille, thermistor, terminal cover,
		and air intake grille.

2