Invacare M71 manual General Guidelines Section, General Warnings

Page 7

GENERAL GUIDELINES

SECTION 1

This Procedure Includes the Following:

Controller Settings/Repair or Service Information

Operating Information

Safety/Handling of Wheelchairs

Label Location

CONTROLLER SETTINGS/REPAIR OR SERVICE

WARNING

Set-up of the Electronic Control Unit is to be performed ONLY by a qualified technician. The final tuning adjustments of the controller may affect other activities of the wheelchair. Reprogramming the controller reduces the stability/controllability of the wheelchair. Other program settings could cause the wheelchair to tip over resulting in serious injury to the user and/or damage to the surrounding property. IF ANY INDIVIDUAL OTHER THAN A QUALIFIED TECHNICIAN PERFORMS ANY WORK ON THESE UNITS, THE WARRANTY IS VOID.

OPERATING INFORMATION

GENERAL WARNINGS

Performance adjustments should only be made by professionals of the healthcare field or persons fully conversant with this process and the driver's capabilities. Incorrect settings could cause injury to the driver, bystanders, damage to the chair and to surrounding property.

After the wheelchair has been set-up, check to make sure that the wheelchair performs to the specifications entered during the set-up procedure. If the wheelchair does NOT perform to specifications, turn the wheelchair OFF immediately and reenter set-up specifications. Repeat this procedure until the wheelchair performs to specifications.

ALWAYS shift your weight in the direction you are turning. DO NOT shift your weight in the opposite direction of the turn. Shifting your weight in the opposite direction of the turn may cause the inside drive wheel to lose traction and the wheelchair to tip over.

DO NOT shift your weight or sitting position toward the direction you are reaching as the wheelchair may tip over.

To determine and establish your particular safety limits, practice bending, reaching and transferring activities in several combinations in the presence of a qualified health professional BEFORE attempting active use of the seating system/wheelchair.

DO NOT attempt to reach objects if you have to move forward in the seat.

DO NOT attempt to reach objects if you have to pick them up from the floor by reaching down between your knees.

GENERAL GUIDELINES

Part No. 1118362 Rev A

7

Power Tilt Only For M71 and M91.

Image 7
Contents Power Tilt only Power Tilt Only For M71 And M91 Part No.1118362 Rev a Table of Contents Special Notes Special NotesWheelchair TIE-DOWN Restraints and Seat Positioning Straps Lable Locations Lable LocationsSpecifications SpecificationsGeneral Warnings General Guidelines SectionGeneral Guidelines Section General Guidelines Rain Test Grounding InstructionsElectromagnetic Interference EMI from Radio Wave Sources Weight TrainingWeight Limitation Electromagnetic Interference EMIGeneral Guidelines Important Information SAFETY/HANDLING of Wheelchairs ESCALATORS? Sorry LIFTING/STAIRWAYSMinimize GAP Distance Percentage of Weight DistributionREACHING, Bending Backward Procedure Safety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistSafety Inspection Troubleshooting General Guidelines Troubleshooting TroubleshootingSafety INSPECTION/TROUBLESHOOTING Section Increasing the Tilt Angle Operating the Power Tilt only FigureSeat Assembly Section Seat AssemblyTilting the Seat Assembly Forward Tilting the Seat Assembly FigureSection Seat Assembly Tilting the Seat Assembly BackDOWN/CLOSED Seat Assembly Section Detail aCharging Batteries Battery Charger OperationRII Joystick Joystick Mark Electronics Section Adjusting Seat Assembly Adjusting the Seat Height FigureM91 Frame Adlusting Seat Assembly Section M71 FrameAdjusting the Seat Position Figure Detail a Detail B M71 Seat Adjustment PositionsMiddle Forward Seat Position Limited Warranty
Related manuals
Manual 116 pages 39.64 Kb