Invacare 2000, 4000 operating instructions Side Frame, Front

I.V. ROD TELESCOPING KIT

9000XT RECLINER - KIT NO. 1074656 2000, 4000 AND 9000 RIDELITE RECLINER - KIT NO. 1029598

Installation, Assembly and Operating Instructions

NOTE: Check ALL parts for shipping damage. In case of		1. Remove the rear wheel from the wheelchair. Refer to
shipping damage, DO NOT use. Contact Carrier/Dealer		REMOVING/INSTALLING THE REAR WHEELS
for further instruction.		in this instruction sheet.
	SAFETY SUMMARY	2. Remove the arm from the wheelchair. Refer to RE-
The following recommendations are made for safe instal-		MOVING/INSTALLING THE ARMRESTS in this in-
		struction sheet.
lation and adjustment of the I.V. Rod Telescoping Kit:
		3. Remove the locknut and hex screw that secure the
	GENERAL WARNINGS
		arm socket to the wheelchair frame.
	DO NOT install or use this equipment with-
		4. Remove the locknut that secures the back tube to the
	out first reading and understanding this
	instruction sheet. If you are unable to un-	clevis bracket.
	derstand the Warnings, Cautions or Instruc-	5. Position the I.V. holder on the existing pivot bolt as
	tions, contact a healthcare professional,	shown in FIGURE 1.
	dealer or technical personnel before at-
	tempting to install this equipment - other-		Hex
	wise, injury or damage may occur.	Arm Socket
	DO NOT pull/push the wheelchair by the	(OUTSIDE of	Screw
	I.V. rod assembly. Injury to the assistant/	Wheelchair
	occupant and/or damage to the I.V. rod	Frame)
	assembly may occur.
	DO NOT place any other objects on the	Locknut	STEP 3
	I.V. rod assembly other than those deter-	Outside of
	mined by a healthcare professional.
		Wheelchair
	INSTALLATION WARNINGS
		Frame

After ANY adjustments, repair or service
and BEFORE use, make sure all attaching	Locknut
hardware is securely tightened - other-	(STEP 8,9,11)
wise injury or damage may result.	Side Frame
Use EXTREME caution when the I.V. rod
holder for MODELS 2000, 4000 and 9000	I.V. Holder
Ridelite is installed. When installed, the rear	(STEP 5)
arm release lever is removed and will NOT
lock the arm in place.	Mounting
NOTE: If installing the telescoping I.V. rod holder onto	Screw
a 2000, 4000 or 9000 RIDELITE, refer to INSTALL-	(STEP 7)
ING THE TELESCOPING I.V. ROD HOLDER - 2000,
4000 or 9000 RIDELITE in this instruction sheet.

Back Tube

(STEP 4)

Clevis

Bracket

(STEP 4)

Pivot Bolt

(STEP 5)

Flat Portion

(STEP 5)

INSTALLING THE TELESCOPING I.V. ROD HOLDER - 9000XT ONLY (FIGURE 1)

NOTE: Refer to INSTALLATION WARNINGS in the

SAFETY SUMMARY in this instruction sheet.

Front	Locknut
	(STEPS 4,6,11 )
Cylinder

FIGURE 1 - INSTALLING THE

TELESCOPING I.V. ROD HOLDER

1