Personal Back Headrest Reinforcement Plate
Assembly, Installation and Operating Instructions
Kit No. 1049522
SAFETY SUMMARY
Check all parts for shipping damage before using. In case of damage, do not use. Contact the dealer for further instructions.
NOTICE
The information contained in this document is subject to change without notice.
WARNING
DO NOT install, maintain or operate this equip- mentwithoutreading,understanding,andfollow- ing the proper Invacare instructions, otherwise in- jury or damage may result.
Your therapist and physician should be consulted ifyouhaveanyquestionsregardingindividuallimi- tations and needs.
HEADREST REINFORCEMENT PLATE INSTALLATION FOR THE 12, 14, 16, 17, 18 AND
NOTE: 13, 15 and
1.Remove the Personal Back from the back canes.
2.Remove the zippered cover from the Personal Back.
3.Mount the Personal Back in bench vise with the front facing you.
4.Push the foam of the Personal Back downward.
5.With hole closest to top edge in the middle of rein- forcement plate (marked "A" - Refer to FIGURE 2) align Personal Back (FIGURE 1) dimples on inside with TOP two (2) corner holes of the reinforcement plate. Clamp plate to Personal Back.
6.Drill (from the inside of the Personal Back) the TOP two (2) corner holes with a
7.Unclamp the reinforcement plate and turn the Per- sonal Back around in the vise.
8.Clamp the reinforcement plate to the outside of the Personal Back, aligning holes on plate with holes drilled in Personal Back.
9.Drill (from the outside of the Personal Back) the BOTTOM two (2) corner holes with a
10.Drill mounting holes in Personal Back for the selected headrest. Refer to FIGURE 2.
11.Unclamp the reinforcement plate and turn Personal Back around in vise.
12.Mount reinforcement plate on inside of Personal Back (FIGURE 1).
NOTE: Position heads of button head screws on the inside of the backrest.
13.Secure reinforcement plate to Personal Back with button head screws and hexnuts.
NOTE: Use appropriate holes in reinforcement plate for mounting selected headrest.
1 | Form No. |