Handicare 1700 manual Battery Indicator, Front and Rear Running Lights

OPERATING YOUR SCOOTER (Cont.)

BATTERY INDICATOR

Reading from left to right; the battery level indicator has three green lights, four yellow lights and three red lights. The batteries are completely charged when all the lights are illuminated. As the battery level decreases the lights will go off one by one, starting on the left.

The indicator lights show the battery voltage available to the controller. It is normal that the indicator goes down during conditions of initial acceleration, as the extra load will cause the voltage to drop momentarily. This momentary drop is not a true reading of battery capacity.

Also, when the scooter is first powered up, there is a momentary self-test to verify and light. The indicator may initially show full charge even if the batteries are not fully charged. This is a characteristic of the batteries. For this reason, the most accurate battery reading is obtained when riding on a flat surface.

If the battery indicator remains in the RED zone, it is important to recharge your batteries as soon as possible.

Never fully discharge your batteries by overuse, as this will shorten battery life and could cause damage to the battery.

LIGHTS

Your scooter may be equipped with one of two light packages.

A. FRONT AND REAR RUNNING LIGHTS

1.To turn on the front headlight and the rear tail lights, push the light ON/OFF button located on the speed control console face plate.

2.To turn the lights off, push the light ON/OFF button again.

B. FRONT AND REAR TURN SIGNAL LIGHTS (movingpeople.net installed option only)

To activate LEFT turn signal indicators: (front & rear) press the signal button on the left side of the console face plate. Push the same button again to turn the signal off.

To activate RIGHT turn signal indicators: (front & rear) press the turn signal button on the right side of the console face plate. Push the same button again to turn the signal off.

Hazard signal: To activate all four signal lights at once, press both the left and the right signal pads and hold for two seconds. Repeat to de-activate.

12