Electra Accessories 88905, 88969 user manual Fuel Lines Cannot RUB or Touch Against, Motor

SERVICE & MAINTENANCE

GAS TANK REMOVAL/GAS DISPOSAL

TOOLS NEEDED:

1 Phillips Screwdriver

1 10mm wrench

1 Draining container or pan

REMOVE SEAT & GAS TANK COVER:

1.Locate seat screws under the back side of the seat(Fig. 1)

2.Remove screws from seat and pull up(Fig. 1)

3.Remove gas cap and screws from gas tank cover (Fig.2) and lift up slightly to expose the ignition wires(Fig.3)

4.Unplug Ignition wire and pull off gas tank cover

Ignition Wires

Fig. 1 Fig. 2 Fig. 3

REMOVING GAS TANK

1.Remove fuel lines from gas tank (Fig. 3)

2.Keep gas tank supported to avoid spillage and remove screws (Fig. 4)

Fuel Lines

Primer Ball

Fig. 4 Fig. 5

REMOVING EXCESS FUEL FROM CARBURETOR

1.Place fuel lines in draining container or pan

2.Push primer ball until all excess fuel empties into draining container or pan (Fig.5).

		OVERFLOW LINE	A.
REINSTALLING FUEL LINES		(CLEAR TUBE)
1. Make sure fuel lines are properly snapped into tank.
2. Make sure the fuel line (Black) reaches the			GAS LINE MUST
bottom of tank (Fig. 6)			REACH BOTTOM
3. Make sure both fuels are connected to			OF TANK.
carburetor and are not touching the motor.			B .
FUEL LINES CANNOT RUB OR TOUCH AGAINST	Fig. 6	GAS LINE	IF GAS LINE DOES NOT REACH
THE MOTOR. FUEL LINES MAY MELT FROM HEAT		(BLACK TUBE) BOTTOM OF TANK, MOTOR-BIKE
			WILL NOT FUNCTION OR RUN
OF MOTOR.
			PROPERLY.

20