Programming the Guest Mode, Troubleshooting

PROGRAMMING THE GUEST MODE

The Guest mode allows you to use the monitor without losing the information already assigned to a Personal Key.

To programme the Guest mode, use the Down button marked with a “G” to turn on the power. Then follow steps 3 through 5 in “Setting and Storing Data” (p.6.) The unit will beep twice and the display will show “0.0”. Step onto the platform. Next follow the directions for “Get Your Reading” (p.7).

Note : If you step onto the platform before “0.0” appears the display will show “Error” and you will not obtain a reading.

TROUBLESHOOTING

If the following problems occur… then…

A wrong weight format appears followed by kg, lb, or st-lb

Refer to “Switching the Weight Mode” on p.5.

“Lo” appears on the display, or all the data appears and immediately disappears.

Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.

Note: Your settings will not be erased from the memory when you remove the batteries.

The display reads “Error” or “- - - - -“appears or the power shuts off while measuring.

Be sure that you have selected the correct user mode (Male/Female, Age, Height). Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the measuring platform. Consider whether or not you have selected the correct Personal data number and make sure that you wait for “0.0” to appear before stepping on the platform. Step off and repeat steps on p.7.

“OL” appears while measuring.

Reading cannot be obtained if the weight capacity is exceeded.

Note: If body fat percentage is more than 75%, readings cannot be obtained from the unit.

The body fat percentage measurement does not appear after the weight is measured.

Vibration will interfere with measurement of the fat percentage. Be sure to stand and still on the measuring platform. Do not bend your knees. Be sure that shoes and socks are removed and check foot alignment. Step off and repeat steps on p.7.