Conair Facial Steamer important safety instructions Instructions, Using Your Facial Steaming Unit

Page 1

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:

READ ALL

INSTRUCTIONS BEFORE USING

KEEP AWAY FROM WATER

DANGER

To reduce the risk of electrocution:

1.Always unplug this appliance immediately after using.

2.Do not use while bathing.

3.Do not place or store appliance where it can fall or be pulled into a tub or sink.

4.Do not place in or drop into water or other liquid.

5.Do not reach for an appliance that has fallen into water or other liquid. Unplug immediately.

WARNING To reduce the risk of burns, electrocution, fire, or injury to persons:

1.An appliance should never be left unattended when plugged in.

2.This product is not to be used by, on, or

near children or by individuals with certain disabilities.

3.Use this appliance only for its intended purpose as described in the manual. Do not use attachments not recommended by the manufacturer.

4.Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or dropped into water. Return the appliance to a service center for examination and repair.

5.Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.

6.To avoid burning, do not pick up the unit while water is hot since water can spill out.

7.Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and other debris.

8.Never use while sleeping.

9.Never drop or insert any object into any opening or hose.

10.Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.

11.Do not use an extension cord with

this appliance.

12.Unplug this appliance before filling. Fill reservoir with tap water only. Do not overfill.

13.Use The Microdermabrasion Facial Spa only on a level surface.

14.Do not use additives.

15.Never place face close to facial steamer in one position as this may cause scalding.

16.To avoid burning, do not touch after plugging in water reservoir unit.

17.Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel cadmium) batteries.

18.Do not use the spa without the mask.

19.Do not place hand in the base.

20.Do not touch steam as it comes out of the base.

21.Do not move or pick up the unit until the water cools.

SAVE THESE

INSTRUCTIONS

OPERATING

INSTRUCTIONS

This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

The Microdermabrasion unit operates on 2 “AA” batteries. For battery

insertion, gently pull down lower cap and insert batteries.

If you have any skin condition, sensitivity to heat, or other health issues

or questions, including those relating to use of this product while undergoing any treatments or taking any medications, please consult with a physician before use.

This product should not be used in the following cases:

Tuberculosis, benign and malignant tumors, inflammations of the skin, phlebitis and thrombosis, open and fresh wounds, bruises, broken skin or varicose veins.

INSTRUCTIONS FOR USING YOUR MICRODERMABRASION SPA

Before beginning, cleanse your face, following your daily care routine. Lightly pat your favorite moisturizer or eye cream around the eye area.

USING YOUR FACIAL

STEAMING UNIT

Your Facial Spa includes two detachable cones:

1.Facial Mask: Use for facial cleaning.

2.Sinus Cone: Use for concentrated steam to assist in respiratory therapy. Place your nose in the sinus cone with forehead touching curved rim. Relax as soothing mist promotes easier breathing, however, do not use as room humidifier.

Turn facial mask or sinus cone counter- clockwise and lift away

from base.

Fill the water cylinder

with warm tap water. Pour

 

water into the reservoir

 

and plug it into a 120 volt

 

AC household outlet. (See

Figure 1

Figure 1)

Place facial mask or sinus cone over unit. Lock by aligning bumps on facial mask with slots over water reservoir and turn clockwise. (See

Figure 2)

Figure 2

Press “ON/OFF” button to turn unit on.

When the power is on, the ready indicator light will flash for 3 minutes as the water is preheating.

When the indicator light has stopped flashing and is steady, you may use the Facial Spa. Unit will automatically shut off after 45 minutes.

FOR A TIMED TREATMENT, the timer control can be set from 3 to 15 minutes by rotating the knob to desired time.

Press the timer start button and the timer indicator light will go on.

The unit will shut off and a buzzer will sound to indicate that preset time has expired.

NOTE: One fill provides between 10-30 minutes of soothing mist. If the facial spa should run out of water, shut off immediately, then begin your facial again.

Clean your face and neck

Allow approximately 3 to 4 minutes for steam mist to develop, then place your face gently against the rim of the facial mask or sinus cone. To avoid burning, do not pick up the unit while water is hot since water will spill out.

If more steam is desired, place a towel over your head that so it covers the mask and sides of the steamer.

Close your eyes and relax as the soothing

mist begins deep cleansing action.

Remove your face occasionally and blot with a cool, damp towel. Steam for a minimum of 5 minutes, but no longer than 30 minutes.

Immediately after steaming, rinse your face with cool water.

INSTRUCTIONS FOR USING YOUR MICRODERMABRASION TOOL

Snap the exfoliating brush attachment onto the unit, making sure it is securely attached.

Apply a generous amount of your favorite exfoliating cream to your face.

At the speed of your choice, massage the cleanser on your face in a circular motion, making sure not to exceed two minutes.

Use for 10 second intervals per area beginning with the forehead; avoiding the eye area, move downwards toward the cheek and nose area then to your chin area. This step exfoliates, thoroughly cleans and removes dulled skin cells. Rinse face and pat dry. Next apply cool water or your favorite astringent to close pores and seal in moisture.

Now you are ready to apply your favorite moisturizing lotion by using the sponge applicator. Dot your forehead, cheeks, nose and chin with a generous amount of mois- turizer and smooth the cream into your skin. Apply light to medium pressure and use upward, circular strokes. After just one personal facial with the Microdermabrasion Facial Spa you’ll find your skin looking fresher and healthier.

Image 1
Contents Instructions Using Your Facial Steaming UnitKeep Away from Water User Maintenance InstructionsAlways Unplug Small Appliances