Southwest Specialty Products 6800 manual Vectored Software Interrupts, Vectored INPUT/OUTPUT

VECTORED SOFTWARE INTERRUPTS

Normally when encountering a SWI (3F) instruction, the computer will display the processor’s registers and SWTBUG® control will be resumed. If desired, the 3F command can be vectored to anywhere in memory, just like the NMI and IRQ interrupts. To use the vectoring capability simply store the service routine address at location A012-A013 in the SWTBUG® RAM. When a 3F is encountered, processor control will be transferred to the memory address stored in A012-A013. Note: each time the system is RESET, A012 will be reset to the location of the register dump routine. This means that any program which uses vectored SWl’s should set up this location each time it is executed. If the location you wish to vector to is 10D0, for example, the following statements at the beginning of the program will set up the vector correctly:

LDX # $10D0	LOAD VECTOR ADDRESS
STX $A012	STORE VECTOR

Vectored software interrupts should not be used in conjunction with breakpoints since the breakpoint routine uses locations A012-A013.

VECTORED INPUT/OUTPUT

If desired, input and output can be vectored to a MP-S or MP-C interface on ports other than #1. Locations A00A-A00B contains the port address that the subroutines INEEE and OUTEEE use for inputting and outputting characters. To use vectored input/output your program must store the desired I/O address in A00A–A00B before any I/O is done. Below is a list of I/O address assignments for each port:

PORT	ADDRESS
0	8000
1	8004
2	8008
3	800C
4	8010
5	8014
6	8018
7	801C

The program statements that would set up the correct port would be as follows:

LDX #$8018	I/O on port 6
STX $A00A	Store

SWTBUG® will look at the port and will self-configure for either a MP-C or MP-S type interface.

NOTE: Any time that SWTBUG‘s control sequence is initiated or when the RESET button is pushed, the I/O address will be reset to port # 1. Therefore complete SWTBUG® monitor control cannot be moved to another port.

USING NON-MASKABLE INTERRUPTS

Using non-maskable interrupts is very similar to using vectored software interrupts. A non- maskable interrupt will occur whenever the NMI line on the computer’s bus is grounded either through hardware or by an ACIA or PIA. When the NMI is seen, processor control will be transferred to the location stored in A006 and A007. For example if an NMI service routine is desired at location 1000 the following statements should be used at the beginning of your program to set up the correct NMI jump address.

LDX #$1000

STX $A006

USING MASKABLE (IRQ) INTERRUPTS

Using regular maskable interrupts is the same as using non-maskable interrupts except that when the IRQ line is grounded processor control will jump to the address stored in A000 and A001. The computer will only respond to the interrupt if the processor’s interrupt mask bit 1 is 0. A CLI instruction at the beginning of your program will insure this condition.

9