Soehnle 7850.02 manual Getting started, Mass unit switchover, Battery exchange, Weighing

■Getting started

1.Install the fitness scale level on a firm, flat surface

2.Connect the plug-in power supply unit without standing on the scale

3.Set the clock and date

Please do not stand on the scale. Keep the or key pressed until the display shows the

year. Press the or key to select­ the re-

quired year and confirm­ . Select the month by

pressing the key and confirm. Select­ the day by pressing the or key and confirm.

The indicator then shows digits­ for setting the clock. Adjust the hour by using the or key and confirm. Do the same with the minutes and

finally­ confirm­ .

■Mass unit switchover

Slide the switch on the rear at any time to switch over the mass unit from “kg and cm” to “lb and ft/ inch“ or “st/lb and ft/inch”.

The default setting of the scale is “kg and cm". The last unit setting is retained even when the appliance is switched off.

0.0 kg

0.0 lb 0: 0.0 st

lb

■Battery exchange:

4.Insert the thermal

paper­ roll (58mm

wide) in the paper compartment (see figure) and pull out

the paper strip by several centimetres. Close the lid and tap the key “7850”

briefly to test whether the paper feeds through correctly. The printer has an easy-load function. There is no need to feed the paper through

manually­ .

5. The scale is ready to operate

Please change the lithium battery when time

and date settings are not correct anymore (without ­power supply of the scale).

■Weighing

Stand on the scale as still and straight as possible while the Fitness Scale measures your weight. After a short period of time, the weight reading appears and the “INPUT" message flashes. If you only want to measure your weight, you can step off the scale now. The weight reading is ­printed out. Otherwise continue as described under Body Analysis.

7 2.2 kg