Cleaning the Mask and Headgear

SECTION 3—CLEANING THE MASK AND HEADGEAR

CAUTION

ALWAYS be sure to remove any foreign material (dirt, lint, etc.) from the exhalation vents.

DO NOT use bleach, chlorine, aromatic-based cleaning solutions, scented oils, or moisturizing or antibacterial soaps to clean the mask components. These solutions may cause hardening and reduce the life of the product.

Alcohol may be used to clean the silicone cushion ONLY. DO NOT use alcohol to clean the mask frame, headgear or air tubing.

WARNING

DO NOT expose any part of the mask system or tubing to direct sunlight as it may cause mask deterioration.

ALWAYS rinse mask thoroughly after cleaning. Insufficient rinsing of cleaning agents can result in severe skin rash, irritation and skin breakdown. Discontinue using the mask if there is an allergic reaction to any part of the mask, and contact your healthcare professional.

Washing the mask in an automatic dishwasher is not recommended. Doing so may damage or affect the life of the valve flap or the product. Also, the automatic dishwasher cleaning and rinsing agents may leave a residue on the mask, which may cause skin irritation.

For multi-patient use/reuse, clinicians should refer to the Mask Disinfection and Sterilization Guide (p/n 1130216).

The headgear cannot be disinfected or sterilized. Refer to instruc- tions below for washing the headgear.

NOTE: Wash the entire mask system (except the headgear) after each use.

NOTE: Wash the headgear at least once per week.

NOTE: ALWAYS hand wash the headgear to increase the life of the product.

1.Disassemble the mask. Refer to Cleaning the mask on page 8.

2.Hand wash the headgear in warm or cool water using a mild detergent.

3.Rinse the headgear thoroughly and allow to air dry.

4.Hand wash the mask components using a mild detergent, such as hand dishwashing detergent, in warm water.

5.Rinse the mask components thoroughly and allow them to air dry.

Part No 1130237

Invacare®Twilight™Full Face Mask