1.INTRODUCTION
Dixonnecl the plug.
|
|
|
|
|
| |
|
|
|
|
| 1. INTRODUCTION | |
|
|
| H When unplugging the power cords, | |||
|
|
| be sure to hold and pull on the plug | |||
n When moving the machines, be | Diiconnecttheplug. | portion. | Pulling on the cord portion | |||
| may cut or expose the internal wires | |||||
sure to first unplug the power cords. |
| |||||
| and cause fire or electric shock. | |||||
Moving the machines with the power |
| |||||
|
|
|
|
| ||
cords plugged in may damage the |
|
|
|
|
| |
cords and cause fire | or electric |
|
|
|
|
|
H Do not lean against | the machine. It |
| n When | opening the | cash | drawer, be |
may fall and be damaged. |
| careful | not to let the | drawer | hit | |
|
|
| children’s heads, etc., as this may | |||
w Be sure to move large scale
machines with two or more people. In addition, machines should be mobed after first confirming that connecting wires between machines and externally connected wires, etc. have been removed. Failure to observe these precautions may result in injury.
Precaution
The following precautions will help to ensure that this machine will continue to function correctly.
@Try to avoid locations that have the following adverse conditions:
l | Temperatures | below 0°C and above 40°C | l | Direct sunlight |
l | Shared power | socket | l | Excessive vibration |
@Do not subject the weighing platter to sudden shocks.
@Do not press the keys too hard. Keys will operate correctly if they are touched lightly.
@Clean the cover and weighing platter by wiping with a dry cloth or a cloth soaked with detergent
and wrung out thoroughly. Never use thinner or other volatile solvent for cleaning.
0To ensure that the scale is operating correctly, place a known weight on the platter and check it
for correct weight measurement. This should be done every morning before starting normal operations.
6At the end of the day, turn the power OFF, then clean and inspect the exterior of the scale.
8 Try to avoid using this equipment on the same power supply as high voltage equipment or equipment likely to cause mains interference (freezer cabinets etc.).
@ USE ONLY TEC SPECIFIED media.
@ DO NOT STORE the media where they might be exposed to direct sunlight, high temperatures, high humidity, dust, or gas.
@ When moving the scale, take hold of the case and lift the scale. Never hold the remote unit.