Using your Straightener.
1.Insert the plug into the power outlet and turn the power on.
2.Move the on/off switch to the on position (I).
3.Select the desired heat level by rotating the temperature dial on the side of the styler. Use lower heat for fine hair, or for smoothing
4.Allow the straightener to heat for several minutes before using.
5.Brush your hair thoroughly. Separate out a section of hair approximately 4cm in width and smooth it with a comb.
6.For best results, start at the scalp and work to the ends of the hair. Place the separated section of hair between the flat plates and close the handle gently around the hair.
7.Hold the styler in position for 3 to 5 seconds, depending on the type of hair (3 seconds for fine hair and up to 5 seconds for thicker hair).
8.Once the hair is heated carefully slide the styler along the section of separated hair, making sure that the hair is heated and straightened all the way to the ends.
9.Select another section of hair and repeat the process. Continue until all of the hair has been straightened.
Care and Cleaning.
After use, remove the plug from the power outlet and allow the styler to cool before storing.
To clean the plates, wipe with a soft cloth moistened with a solution consisting of a small amount of hair shampoo in warm water. Wipe the outside of the styler with a damp cloth, and dry with a soft cloth.
Do not wrap the cord around the styler when not in use. Store in a dry place.
Sunbeam is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. Approved by the appropriate Electrical Regulatory Authorities. Backed by Sunbeam‘s 2 Year Replacement Guarantee and National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2002. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on this or any other Sunbeam appliance, visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Australia 1800 025 059 New Zealand (09) 912 0747.