Cybersonic Power Toothbrush manual System, Answers, Using, Tongue Cleaning Attachments

(*6 Day Treatment, Skip Day 7 – No Treatment)

Tongue Cleaning Attachments

1. Place the sonic tongue cleaning attachment onto the power handle and use with or without paste/gel.

Sonic Agitation Ribs/Ridges

Commonly Asked Questions

Q. Will the system loosen crowns, fillings or other permanent dental work?

A. No, they are designed to be used for all dental work.

Q. How often should I replace my brush heads?

SYSTEM

2.Place the tongue cleaner into your mouth and on top of your tongue. Use light pressure and rub over the top surface in back and forth motions. Pull or scrape the residue out and expel.

Remove

Odor Causing

Elements &

Residue

A. Dentists recommend changing every three months. Your brush may not	ANSWERS
look worn but it is, and a worn brush does not clean well.
Q. Is it safe to use for a person with a pacemaker?

USING THE

10

Sonic White® One-Step Bleaching Gels

1.Apply the gel onto the brush head. Push the plunger in until it reaches the first dosage marker. Each notch equals one day’s treatment

(replace end cap on syringe).

2. Spread an even film of gel across your teeth and work the

gel using small circular motions.

Continue for one to two minutes for stubborn stains. Rinse and look for results within one to three weeks.

*Contains no animal by-products. Deionized water, Hydrogen Dioxide 7.5%, Carbopol and Triethanolamine.

Note: One syringe contains a one-week treatment; six days on, one day off. A one-week treatment is enough for normal yellowing or stains. Continue for additional one to two weeks for more stubborn stains. Sonic White is safe for daily use. For best results, do not bleach teeth right after using a fluoride toothpaste or rinse. During normal use, minor gum or tooth sensitivity may occur or white film or spots may appear, but are harmless and temporary. If you experience prolonged sensitivity, pain or bleeding gums, stop use and consult your dentist.

Sonic Flosser Attachments Plus Pre-Strung Replacement Heads

1.Place the flosser attachment onto the power handle. Then snap the pre-strung replacement head into the flosser attachment.

2.Turn on the power handle. Insert floss between teeth.

For tight teeth, you may need to move the flosser from side to side.

3. To clean between your teeth, slide the floss up and down both sides of your teeth. Also floss under the gum line.

4.To replace the used flossing head, place thumbnail under base and snap upward and out.

5.Dispose of replacement heads after each use. Order replacements by calling 1-800-774-7525.

A. It is always advisable that a person with a special medical conditions,	&
including pacemakers, consult with a physician or pacemaker
manufacturer.
Q. Can I travel with my power toothbrush?
A. Yes. A fully charged brush will hold a charge for at least a week of
normal use, and the brush head cap keeps the bristles clean.
	QUESTIONS

Q.Is it suitable for kids?

A.Yes. The original round brush is actually a perfect size for children. You may start your kids using the system at the same age you would a manual toothbrush. Parental supervision is always advised with a new oral cleaning product.

Q.Why do I sometimes need to push the ON/OFF button more than once?

A.The electronic switch takes 1 second to re-set before it will respond to another push. Simply wait 1 second before pushing the button again.

Q.How do I purchase replacement attachments?

A.Replacement attachments may be purchased at your local retailer or by calling 1-800-774-7525. You may also access our web site at www.amdencorp.com.

11