Salter Housewares Inset Electronic Bathroom Scale Introduction, List of Contents, Care/Advice

INTRODUCTION

This product has a stainless steel tray, designed to be recessed into a floor.

Installation of the tray should be performed by a competent professional builder.

The scale is a precision weighing instrument.To prevent the risk of damage to the scale, store it away in a safe and clean environment, until all building work is complete. Under no circumstances must the scale be dropped or overloaded as that could damage the electronic weight sensing system.

For England and Wales, LANTAC (local Authority National Type Approval Confederation) has awarded this system installation, National Type Approval (SA-144-12-7010):The design and method of construction, for the installation of this inset electronic bathroom scale, has been examined, and has been shown to be capable of complying with current building regulations. For other countries, the installer must ensure that the installation complies with the building regulations in force for that country.

	LIST OF CONTENTS
• Electronic scales	• Installation template
• Stainless steel tray	• Installation manual
• Stainless steel screws x 8	• Operating instructions and guarantee

CARE/ADVICE

• Scale is watertight - when in tray, but do not remove and immerse

• If the scale is to be used without the tray, then position on a hard flat floor - not a carpeted floor

• Remove any water that may collect in the tray

OPERATING INSTRUCTIONS

Important - install this product with reference to the enclosed installation manual

BATTERIES - 2 X CR2032

Remove battery cover using a coin, remove battery and then pull out isolating tab. Replace batteries and battery cover.

OPERATING KEY

WEIGHT MODE

To change weight mode:

1.The scale must be off

2.Use a finger to press and hold down the operating key - display will show ‘--’

3.Continue to hold down for a further 4 seconds

4.Display will show the current operating weight mode by st-lb, lb, kg in small characters along the top of the display

5.Continue to hold key down and the display will begin to cycle through the weight modes at 4 second intervals (eg. kg to st-lb to lb and back to kg)

6.Release the operating key when the desired weight mode is displayed

7.The current weight mode setting will be stored for next time

OPERATION

Operation procedure is as follows:

1

1.Using a finger press and release the operating key - display will show ‘--’

2. Wait 3 seconds

3.Display will show ‘0.0’ - scale is ready for use

4.Step on to the platform, ensuring feet are within the outer perimeter of the

2

GB

OPERATING KEY

LOCK UNLOCK

Operating key can be slid in to lock it, and pulled out to release. Pull out and press to remove scale from tray.

	platform, and without your feet touching
	the tray	3
5.	Stand very still - the display will show ‘----’
	scrolling up the display
6.	Wait 5 seconds
7.	Your weight is displayed
8.	Scale will auto-off after approximately
	7 seconds

4

GB

2 3