Calling up readings from memory

CAUTION:

•For persons with poor circulation resulting from diabetes, liver disease, arteriosclerosis, high blood pressure or other conditions, there may be significant differences in blood pressure values measured at the wrist versus at the upper arm.

•Do not confuse self-monitoring with self-diagnosis.

•NEVER change a prescribed medication without first consulting with your physician.

Storing blood pressure readings

Fig. 10-a

(After approx. one second.)

Fig. 10-b

Readings can be recalled after being saved without having to switch the unit on.


1.	Press the Memory/Recall button.
• The average readings of all recorded measurements
	are displayed.
• The		mark will be displayed (Fig. 10-a).
• When, for example, readings from 21 measurements
	have been saved the average of the readings from 21
	measurements will be displayed.
2.	Press the Memory/Recall button to display readings
	starting with from the most recent measurement.

Fig. 9-a

(After approx. one second.)

Fig. 9-b

1.The mark will flash after a measurement has been completed (Fig. 9-a).

Press the Memory/Recall button.

2.Memory storage is completed.

•Readings of up to 21 measurements can be stored in memory (Fig. 9-b). Readings over the memory capacity will be recorded over the oldest measurement in memory.

•Readings cannot be saved when a measurement has been unsuccessful (display of the error mark for blood pressure readings). Readings can be saved, however, when the mark is displayed for the pulse rate.

• Each time the Memory/Recall button is pressed

readings are displayed in order of the most recent

measurement (Fig. 10-b).

• No readings will be displayed when there are none in

the memory.

3. Press the On/Off and Start button to switch off the

unit.

If you forget to switch off the unit it will do so

automatically after approx. 30 seconds.

Deleting all data stored in memory

(1)Recall stored data using the Memory/Recall button.

(2)Press the Memory/Recall button again and hold it (for approx. 3 seconds) until all readings are deleted.

NOTE: Readings from individual measurements cannot be deleted.

(3)When data has been deleted the mark and will be displayed on the screen.