Panasonic EW3037 Alarm function signals high blood pressure, Storing blood pressure readings

Alarm function signals high blood pressure

Blood pressure values for both systolic and diastolic readings are determined and indicated via a three-color LED system as being within normal or hypertensive ranges based on definitions and classification of blood pressure levels by the JNC 7. Moreover, when blood pressure is in the high range, the reading displayed on screen flashes on and off to alert user.

According to JNC 7 Classification, values consistently in excess of 140 mmHg (Sys.) and/or 90 mmHg (Dia.) are considered to constitute high blood pressure.

CAUTION:

•For persons with poor circulation resulting from diabetes, liver disease, arteriosclerosis, high blood pressure or other conditions, there may be significant differences in blood pressure values measured at the wrist versus at the upper arm.

•Do not confuse self-monitoring with self-diagnosis.

•NEVER change a prescribed medication without first consulting with your physician.

Fig. 8 Blood pressure sign

LED Colors

Diastolic

(mmHg)

Hypertension

Storing blood pressure readings

120

80

Orange

Yellow

Green

90

80

(Stage 1, Stage 2)

Prehypertension

Normal

120140 (mmHg) Systolic

Fig. 10-a

Fig. 10-b

(NOTE: The time and date of measurements will not display correctly unless set beforehand.)

1.	The	mark will flash after a measurement has
	been completed with sounds (Fig. 10-a).
	Press the Memory/Recall button.
2.	Memory storage is completed.
• Readings of up to 90 measurements can be stored in

Fig. 9-a

• Blood pressure readings will flash for approx. 6 seconds when in the high blood pressure range (Fig. 9-a).

Systolic blood pressure: 140 mmHg and over

Diastolic blood pressure: 90 mmHg and over (Only when measurement is complete)

When an Error Occurs During Measurement

M/ R

Fig. 10-c

memory with sounds (Fig. 10-c, 10-d). Readings over

the memory capacity will be recorded over the oldest

measurement in memory.

• Readings cannot be saved when a measurement has

been unsuccessful (display of the error mark for

blood pressure readings). Readings can be saved,

however, when the mark is displayed for the pulse

rate.

Fig. 9-b	An will appear on the display to indicate that measurement
	was unsuccessful and should be performed again (Fig. 9-b).
	Before performing another measurement, always press the
	On/Off and Start button to turn off the unit and make sure to
	allow a rest period of 4 to 5 minutes before starting again.

Please consult your doctor without delay if the blood pressure indicator repeatedly draws attention to elevated blood pressure values.

17

Fig. 10-d	(After approx.
	one second.)

18