Sunbeam SH3700 manual Help Line, Changing the foil and cutter blocks, Replacing the shaving foil

Page 8

Care and Cleaning continued

Changing the foil and cutter blocks

Shaving performance depends on the condition of the foil and the cutter blocks. Both wear gradually in use. Therefore it is recommended that the shaving foil be changed once a year and the cutter blocks changed every two years.

Replacing the shaving foil

Remove the shaver head by pressing the two release buttons.

Pull the shaving foil out of the shaver head by holding it on the attached straps (fig. 4).

Figure 4

Place the new shaving foil in the shaver head until it clicks in position.

Replace the shaver head.

Replacing the cutter blocks

Remove the shaver head

Hold the cutter blocks on both sides and lift them from their supports (fig. 5).

Figure 5

Place the new cutter blocks in position.

Replace the shaver head.

Help Line

If you have any additional questions about using the Washable Shaver, please call the Sunbeam help line in Australia on 1800 025 059. In New Zealand, please call 0800 786 232.

6

Image 8
Contents Washable Electric Shaver Contents Sunbeam’s Safety Precautions Safety Precautions for Your X-PRESS Washable ShaverFeatures of your Washable Shaver Cleaning brush Shaver head release buttons AC Adaptor Charging Using your Washable ShaverUsing your Shaver Cleaning without water Care and CleaningCleaning with water Help Line Changing the foil and cutter blocksReplacing the shaving foil Replacing the cutter blocksBattery Disposal Year Replacement GuaranteePage Copyright. Sunbeam Corporation Limited Consumer Hotline