Spectrum Brands WSF-1000 manual How to Use

Charging Your Shaver

Before using your rechargeable shaver for the first time, you will need to charge it for 18-24 hours; it will recharge more quickly after its initial charge.

1.Put the charging headguard that came with the shaver, on the shaver and plug its cord into an electrical outlet.

2.The green light indicates your shaver is charging. The shaver cannot be over- charged, so you can leave it plugged in and charging between shaves.

To preserve the life of the batteries,

let them fully run out every six months, then recharge them for a full 24 hours.

Charging Cautions

■Make sure the shaver and your hands are dry when placing the shaver in the charging headguard.

■Always charge the shaver in a cool, dry place.

■The charging headguard can only be used in North America (120V, 60Hz).

Operating Your Shaver

■Remove the protective headguard before shaving.

■Press the ON/ OFF

button to turn the shaver on.

■Hold the shaver so the

screen touches your skin. This allows the shaver to work the way it was designed for the closest shave and minimum wear.

■After shaving, press the ON/OFF button again to turn the shaver off.

■Rinse the shaver head and replace the protective headguard.

Usage Tips

■Use a light touch when shaving.

Pressing hard only flattens your hairs, making it harder for them to enter the cutting chamber.

It will also wear out the cutting surface of your shaver more quickly.

■For best results, shave against the direction your hair grows.

■If you’ve been shaving with a blade, your skin may need up to 3 weeks to adjust to an electric shaver. Once your skin adjusts, you’ll get an incredibly close, comfortable shave.

■After shaving, apply a moisturizing lotion to make your skin feel even more silky.

Wet/Dry Use

All Smooth & Silky® shavers give you a great, close shave wet or dry. Your Smooth

&Silky Slim® shaver is fully submersible in water, so you can shave with foam or soapy lather, in the shower or the tub.

Dry use is great for a quick, close shave when you’re in a hurry; no special preparation is necessary. After shaving, wet or dry, simply run the shaver under cold water to clean it. (See “Cleaning & Maintenance” section for details.)

Wet/Dry Tips

■When using soap or foam lather, the shaver will glide smoothly over the skin, cleansing away oil residue while leaving skin soft and smooth. Apply the soap or foam generously. Do not use non- lathering shaving cream, nourishing cream, or skin lotion, as these will clog the shaver’s screens.

■Wait until you’ve been in the shower or bath a few minutes before you begin shaving, so skin and hairs are fully hydrated. This leads to a closer wet shave.

Wet/Dry Cautions

■Charging devices are not submersible.

■Always use cold or warm water to rinse your shaver. Very hot water, sea water, or cleanser could damage it.

■Do not leave the shaver submerged in water.

Operating The Trimmer

All Smooth & Silky® shavers are equipped with a trimmer that works with the foil

to give you an extra close and comfortable shave.