HOW TO USE
1) OIL
Before every use, check to be sure the blades are properly oiled.
-To maintain your clipper in good condition, the blades should be oiled every few haircuts.
-Only use supplied blade oil.
-Do not use hair oil, grease or oil mixed with kerosene, as it will evaporate and
leave a thick solvent – slowing the blades motion.
IMPORTANT: ALWAYS KEEP THE BLADES OILED. APPLY
2)OPERATION Recharge the unit
• Turn the ON/OFF switch to OFF position
• Connect the groomer to the AC adaptor.
• Plug AC/DC adaptor into outlet.
• The green LED charging indicator should be illuminated.
• Standard recharging time:
• After charging, unplug the adaptor from the main outlet and disconnect from the groomer.
• A fully charged groomer can operate continuously for
Note: Do not over charge. Continuous recharging over 24 hours is not recommended.
3) INSTRUCTIONS FOR INTERCHANGEABLE BLADES
Important – Never use the product to cut wet hair. It is designed to work on dry hair only. This unit has five interchangeable grooming attachments:
•Narrow blade for detail trimming - may be used with the 3 (three) adjustable length attachments for cutting hair
•Wide blade for hair and beard trimming
•Foil shaver for
•Rotary nose/ear hair trimmer
•Linear nose/ear hair and detail trimmer
CLEANING AND MAINTENANCE
•Disconnect the product from the AC/DC charger before cleaning.
•Switch groomer to off position.
•Clean with the supplied brush and a damp cloth. Do not use solvents or abrasive products to clean groomer.
•Remove clipper attachments and rinse under water.
•Always store the set in the bag and store in a dry place.
This warranty provides you with specific legal rights. You may have additional rights which may vary from state to state. Because of individual regulations, some of the above limitations and exclusions may not apply to you.
For more information regarding our product line in the USA, please visit: www.siproducts.com
For service or repair - do not return this unit to the retailer. Contact SI PRODUCTS Consumer Relations at
6
7