Operating Instructions

S I M P L Y A M A Z I N G ®

USER’S GUIDE

ELECTRIC

FABRIC SHAVER

MODEL XJ-350

		•IMPORTANT•
		SAVE THIS BOOKLET!
		Includes:
		Includes:
REGISTER YOUR PRODUCT		Important Safety Instructions
REGISTER YOUR PRODUCT		Warranty
	ON THE WEB:	Operating Instructions
WWW.ORECK.COM

Using the Fabric Shaver

•Plug A/C power adapter into adapter input (Item 5) or use fabric shaver with batteries (see battery use below).

•Turn fabric shaver on by using the one touch sliding On/Off switch (Item 1).

Place fabric you wish to renew on flat surface. Holding the device by its handle, gently move it over the fabric. Pull the fabric as straight as possible to increase the efficiency of the device and the results of the fabric repair.

Useful Tips:

•Tuck in exposed threads before shaving wool sweaters or any other types of fabric to prevent damage.

•Test the fabric shaver on a hidden or inconspicuous area before using it on the entire fabric surface.

•Do not press the device too hard against the fabric as it may cause damage.

•It is recommended to put a small amount of lubricating oil on the inner side of the metal screen cover to allow best possible operation of the unit. Make sure lubricating oil is not present on shaver before using to avoid fabric staining.

•After each use, or when storage box is half full, pull out the storage box (Item 3) and dispose of the fabric shavings inside.

•When efficiency of the device becomes low, open the screen

cover (Item 4) by unscrewing it counter-clockwise. Carefully take out the cutting blade, then clean the blade and inner compartment with the soft brush included.

•The device is equipped with a safety switch that will disable operation when the screen cover is loose or opened.

•Do not use this device to shave easily damaged fabric like Angolan Fabric. Intricate designs or patterns may be damaged during shaving process.

BATTERY USE

To insert batteries for battery use, grab both sides of the storage box at the bottom of the unit and slide out. Open the cover of the battery compartment upward. Using four (4) “C” size batteries, install according to positive “+” and negative “-” signs on battery cover, and then place cover back and snap shut. Slide the storage box back into place.

©2003 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC. Printed in America

40199-01 REV A 4/03