Linear PERS-2400B Testing Transmitters, Local Programming with RA-2400, Erasing Transmitters

13. TESTING TRANSMITTERS

1 PRESS TEST BUTTON

• 4 BEEPS SOUND (TEST MODE)

2ACTIVATE EACH OF THE

CONSOLE'S TRANSMITTERS,

ONE AT A TIME

3COUNT THE NUMBER OF BEEPS

THAT THE CONSOLE SOUNDS

WHEN THE TRANSMITTER

IS ACTIVATED

1-BEEP = TX OK

2-BEEPS = TX HAD ALARM

3-BEEPS = TX MISSED STATUS

4-BEEPS = TX HAS LOW BATTERY

NOTE: WITH THE MODEL VB-4B VOICE BOARD

INSTALLED, THE CONSOLE WILL ANNOUNCE

THE TRANSMITTER STATUS

4PRESS CLEAR TO RETURN TO OPERATE MODE

•2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED

•3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED

THE CONSOLE WILL RETURN TO OPERATE MODE

AUTOMATICALLY AFTER 3 MINUTES

15. LOCAL PROGRAMMING WITH RA-2400

1PERFORM THE STEPS DETAILED IN THE RA-2400/PERS-2400 REFERENCE GUIDE (P/N 217163) TO SET UP THE RA-2400 PROGRAM

2 TO LOCALLY PROGRAM
THE CONSOLE, CONNECT
THE MODEM'S LINE JACK
TO THE CONSOLE'S LINE	LINE-TO-LINE
JACK

3 PRESS TEST BUTTON MOMENTARILY

• 4 BEEPS SOUND (TEST MODE)

NOTE: CONSOLE WILL EXIT TEST MODE

AUTOMATICALLY AFTER 3 MINUTES

OR BY PRESSING THE CLEAR BUTTON

4WHEN RA-2400 CONNECTION TIMER STARTS COUNTING DOWN, PRESS THE EMERGENCY BUTTON

• 4 BEEPS SOUND (RA-2400 ANSWER)

5PERFORM PROGRAMMING IN THE RA-2400 SOFTWARE, THEN DISCONNECT FROM THE CONSOLE

14. ERASING TRANSMITTERS

CAUTION: ALL TRANSMITTERS

WILL BE ERASED!

1PRESS AND HOLD TEST BUTTON FOR 5 SECONDS

• 6 BEEPS SOUND (ALL TRANSMITTERS WERE ERASED)

2PRESS CLEAR TO RETURN TO OPERATE MODE

•2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED

•3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED

THE CONSOLE WILL RETURN TO OPERATE MODE

AUTOMATICALLY AFTER 3 MINUTES

16. TELEPHONE CONNECTIONS

LOCAL	TELEPHONE
TELEPHONE	JACK
	CONSOLE WITH
	REAR COVER
	INSTALLED
ROUTE CABLES UNDER
STRAIN-RELIEF TABS
CONNECT LOCAL	CONNECT TELEPHONE
TELEPHONE TO
THIS JACK	LINE TO THIS JACK

4