Shaving, For best results | Braun Z60 specification

•Using the special cord set, connect the shaver to an electrical outlet with the motor switched off.

•When charging for the first time or when the appliance is not used for a few months, leave the appliance to charge continuously for 4 hours.

•The charging light (5) shows that the appliance is being charged. When the battery is fully charged, the charging light turns off. Intermittent blinking after a while indicates that the battery maintains its full capacity. This can also happen short term when charging after the battery was completely discharged.

•A full charge provides 30 minutes of cordless shaving time depending on your beard growth.

•Once the shaver is completely charged, discharge the shaver through normal use. Then recharge to full capacity. Subsequent charges will take about 1 hour.

•Maximum battery capacity will only be reached after several charging/discharging cycles.

•5-minute quick charge is sufficient for a shave.

Shaving

First, remove the trimming attachment (7): Using your thumbs, press against the side clips of the trimming attachment so that they swing off in the direction of the arrows (a). Activate the on/off switch (6). The floating foil frame automatically adapts to your skin surface for a close, smooth shave.

For best results:

•Always shave before washing your face.

•At all times, hold the shaver at right angles (90°) to the skin (b).

•Stretch the skin and shave against the direction of beard growth.

•For pre-shaving after a few days of not having shaved, use the wide shaper (4a) to pre-cut long hairs. For a close, smooth shave, finish with the foil.

•To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn.

This appliance is suitable for use in a bath or shower.

When using it in the shower, we recommend applying shaving foam or gel.