Braun Clean&Renew™ has been developed for cleaning, charging and storing your shaver. Clean your shaver daily in the Clean&Renew™.
During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver.
Important
•Only use the low voltage adaptation system supplied with the shaver.
•In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface or use the wall holder (not included in all versions). Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed.
•Do not place the appliance in a mirror cabi- net, nor store it over radiators, nor place it on polished or laquered surfaces. Do not expose to direct sunlight.
•The appliance contains highly flammable liquid. Keep it away from sources of ignition. No smoking.
Keep out of reach of children. Do not refill cartridge. Use only original Braun refill cartridge.
•When cleaning the shaver, its protection cap should be removed.
A Description
1Lift button for cartridge exchange
2Contact bow
3Release button
4Operation mode selector
5«clean» light:
cleaning process indicator
6«charge» light:
charging process indicator
7«cartridge» light:
cartridge replacement indicator
8Cleaning cartridge
Wall holder (not included in all versions) Mount the wall holder with plugs and screws to a smooth wall so that the standing surface for the Clean&Renew™ is horizontal.
Technical specifications
•Power consumption:
3 W when cleaning
7 W when charging
•Power supply: 100
•Input voltage: 12 V
B Before using Clean&Renew™
Only applies for cordless shavers:
For the first charge of the shaver, connect the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the Clean&Renew™.
If the rechargeable battery is discharged, select the combined «clean» + «charge» programme rather than the «clean» programme alone.
Installing the cartridge
•Press the lift button (1) to open the housing.
•Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid from the cartridge. Slide the cartridge into the base as far as it will go.
•Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge.
16