Braun 590CC-4, 550CC-4 manual English

Page 29

English

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver.

Warning

Your shaving system is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock.

This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance.

To prevent the cleaning fluid from leaking, ensure that the Clean&Renew station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface.

The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator.

Do not refill the cartridge and use only original Braun refill cartridges.

Oil bottle

Keep out of reach of children.

Do not swallow.

Dispose of properly when empty.

Description

Clean&Renew™ station

1Level indicator

2Lift button for cartridge exchange

3Station-to-shaver contacts

4Start button

5Station power socket

6Cleaning cartridge

Shaver

7Shaver foil

8Cutter block

9Foil release buttons

10Long hair trimmer

11Comfort setting switch «sensitive»

12Shaver-to-station contacts

13On/off switch

14Shaver display

15Cleaning light (yellow)

16Replacement light for shaving parts

17Shaver power socket

18Special cord set

19Etui

A Before shaving

Prior to first use, you have to connect the shaver to an electrical outlet using the special cord set (18) or alternatively, proceed as follows:

Installing the Clean&Renew station

Using the special cord set (18), connect the station power socket (5) to an electrical outlet.

Press the lift button (2) to open the housing.

Hold the cleaning cartridge (6) down on a flat, stable surface (e.g. table).

Carefully remove the lid from the cartridge.

Slide the cartridge into the base of the station as far as it will go.

Slowly close the housing by pushing it down until it locks.

29

Image 29
Contents Series Page Page Page Page Page Page Series Stop Stop Page Rie Ensitiv s Series Page Wo l Page Lul Iti Page Page Page Page Page Page 590 New New Old English Shaver display Manual cleaning Accessories Page Page Page 99503127/IV-10