Panasonic MC-E761 specifications Thermal CUT-OUT, Carbon brushes

REPLACEMENT OF MAIN PARTS

(2) Carbon brushes

NOTE: The two carbon brushes should be replaced at the same time.

1.Take out motor unit and remove motor cover A and B as explained previously in paragraph (1) “Motor”, points 1-6.

2.Disconnect yellow and black lead wires (provided with quick-connect terminals) from the carbon brush holder tabs.

3.Bend the metal end of the carbon brush holder and take out the carbon brush. (Fig. 8)

4.Cut off the metal end of the carbon brush. (Fig. 9)

5.Insert the new carbon brush into the brush holder and push the carbon brush until the protruded pins of the brush holder fix into the holes of the metal end. (Fig. 10)

6.Connect yellow and black lead wires to the carbon brush holder tabs and reassemble motor unit.

7.Place motor unit and cord reel ass’y into the lower body.

8.Connect the lead wires according to the schematic diagram and reassemble the remaining parts in the reverse order.

•THERMAL CUT-OUT

1.Take out cord reel ass’y and motor unit as explained previously in paragraph (1) Motor, points 1-4.

2.Take out thermal cut-out from its fastening points and disconnect lead wires (provided with quick-connect terminal) from the thermal cut-out tabs. (Fig.11)

3.Replace the thermal cut-out with a new one and connect the lead wires to the tabs. Then re-install it.

4.Place motor unit and cord reel ass’y into the lower body.

6.Connect the lead wires according to the schematic diagram and reassemble the remaining parts in the reverse order.

Metal end	Cut metal end
	Carbon
	brush
Fig. 8	Fig. 9

Carbon brush

Metal end

holes

Fig. 10

Termal cut-out

Thermal

cut-out

tabs

Fig. 11

12