•The green charging light shows that the shaver is connected to the mains.
•The capacity of the cell unit is indicated by 20 % segments on the LCD display.
When all segments are visible on the LCD display, the cell unit is fully charged and the green charging light goes off.
A full charge will give up to 60 minutes of cordless shaving depending on your beard growth. However, the maximum capacity will only be reached after several charging/discharging cycles.
•As of 9 minutes remaining capacity, the LCD displays the minutes left.
If the shaver is switched on, the red light is flashing to remind you to recharge the cell unit. The red light goes off as soon as the capacity is down at «0».
•Cleaning symbol (see 5.1)
4 Shaving
4.1Switch lock
The shaver is delivered with the switch lock
activated (position «• lock»). Push the switch lock to position «•» before you shave for the first time. To avoid accidentally switching the shaver on, e. g. when travelling, push the switch lock to position «• lock».
4.2Switch positions
0 = Off
1 = Shaving with the pivoting head.
The pivoting cutting system automatically adjusts to every contour of your face.
2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. g. under the nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
4.3Shaving with the cord
If the cell unit is discharged, you may also shave
with the shaver connected to the mains
(100 - 240 V Q). (If the shaver should not run immediately, charge it with the switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
•We recommend to shave before washing, as the skin tends to be slightly swollen after washing.
•Hold the shaver at right angles (90°) to the skin.
•Stretch your skin and shave against the direction of beard growth.
5Keeping your shaver in top shape
5.1Cleaning
•After shaving, switch the shaver off. Press the release button, take off the triple shaving frame and gently tap it out on a flat surface.
•Then thoroughly clean the duo cutter block with the brush as well as the inner area of the pivoting head.
•A cleaning symbol appearing on the LCD display is supposed to remind you to thoroughly clean your shaver.
•About every four weeks, clean the duo cutter block with Braun cleaning agents.
5.2Changing the shaving parts
To maintain optimum shaving performance, you should replace the triple shaving frame or the duo cutter block, when these parts are worn.
4 | 5 |