Manual cleaning
Remove the shaver foil (shaver head must be in central position) and, using the brush, clean the cutter block and the inner area of the shaver head. Do not clean the shaver foil with the brush.
When cleaning the shaver under running water, make sure it is completely dry before putting it into the Clean&Charge.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil frame and cutter block every 18 months and get a 25% better shave.* (Shaver foil and cutter block: part no. F/C505, available at your dealer or Braun Service Centres).
*(Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months.)
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every
6 months approximately. During this time clean only manually and not in the Clean&Charge. Then recharge the shaver to full capacity again.
Do not expose the shaver to temperatures of more than 50 °C for longer periods of time.
Environmental notice
This appliance is provided with nickel- cadmium batteries. To protect the environ- ment, do not dispose of this appliance in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or appropriate collection sites. However, if you prefer to dispose of the product yourself, remove the batteries as shown.
Cd |
Caution: Opening the housing will destroy the appliance and invalidate the guarantee.
Subject to change without notice.
This product conforms to the EMC- Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC).
Electric specifications see type plate on the product‘s housing.
31