English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.
Warning
Your shaver is provided with a low voltage adapter. Therefore you must not exchange or manipulate any part of it. Otherwise there is a risk of electric shock.
Description
1Shaver foil
2Cutter block
3Release button
4On/off switch
5Long hair trimmer
6Charging light (green)
7Special power supply cord set
Charging the shaver
•When charging for the first time: Using the power supply cord set, connect the shaver to the mains with the motor switched off.
Charge it for at least 4 hours (special cord adapter and shaver might get warm). Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again.
•A full charge will give up to 40 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
•Best environmental temperature range for charging is 15 °C to 35 °C.
•When fully discharged, you may also shave with the shaver connected to the mains via the power supply cord set.
Indicator lights
The green charging light shows that the shaver is being charged. When the recharge- able battery is fully charged, the charging light
goes off. If later on, the charging light comes again, this indicates that the shaver is being recharged to maintain its full capacity.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
•We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
•Hold the shaver at right angles (90°) to the skin. Stretch your skin and shave against the direction of beard growth.
•To maintain 100% shaving performance replace your foil and cutterblock every 18 month or when worn.
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under hot running water is an easy and fast way to keep it clean:
•Switch the shaver on (cordless) and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next switch the shaver off and press the release button (shaver head must be in central position). Lift the shaver foil off and pull the cutter block out. Then leave the disassembled shaving parts to dry.
21