Description
1Shaver foil protection cap
2Shaver foil
3Cutter block
4Release button
5On/off switch («start/stop»)
6Long hair trimmer
7Charging light (green)
8Cleaning light (yellow)
9Replacement light for shaving parts
10Reset button
11Special cord set
Charging
The best environmental temperature for charging is between 60 °F to 95 °F/15 °C and 35 °C.
•First charge: Using the special cord set, connect the shaver to an electrical outlet with the motor switched off and charge the shaver for at least 4 hours.
•The green charging light blinks when the shaver is being charged. When the battery is fully charged, the charging light lights permanently.
•A full charge provides up to 50 minutes of cordless shaving time depending on your beard growth.
•Once the shaver is completely charged, shave without the cord. With normal use the shaver will be charged automatically after every cleaning in the Clean&Renew™ (see separate use instructions).
•Maximum battery capacity will only be reached after several charging/discharging cycles.
•
8hours.
•
1hour.
•If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
•It can take up to
•Shave before washing your face or taking a shower, as skin tends to swell after washing.
•The drier the skin, the closer the shaving results will be.
•Hold the shaver at right angles (90°) to the skin. Stretch the skin and shave against the direction of beard growth.
•To maintain 100% shaving performance, replace the shaver foil and cutter block, when the replacement light (9) comes on (after about 18 months), or when the shaving parts are worn.
Keeping your shaver in top shape
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Renew™, and certainly when the yellow cleaning light (8) shines constantly after shav- ing. If this is not done, the yellow light will go out after some time. The shaver`s electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started. During the cleaning process in the Clean&Renew™ the yellow light will flash and will go off after approx. 4 hours when cleaning is finished.
8