English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.
Warning
Your shaver is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock.
Description
1Shaver foil
2Cutter block
3Release button
4On/off switch
5Long hair trimmer
6Charging light
7Special cord set
Charging
The best environmental temperature for char- ging is between 15°C and 35°C.
•Using the special cord set, connect the shaver to an electrical outlet with the motor switched off.
•When charging for the first time, leave the shaver to charge continuously for at least 8 hours.
•As soon as you start charging the shaver, the charging light (6) comes on.
•Once the shaver is completely charged, discharge the shaver through normal use. Then recharge to full capacity.
•A full charge will give up to 30 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
•4745 model only: If the rechargeable bat- teries are discharged, you can shave with- out charging by connecting the shaver to an electrical outlet via the special cord set.
Shaving
Press the on/off switch (4) to turn the shaver on.
Trimmer: When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
•We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
•Hold the shaver at right angles (90°) to the skin. Stretch the skin and shave against the direction of beard growth.
•To maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn.
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under hot running water is an easy and fast way to keep it clean:
•Switch the shaver on and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive sub- stances. Rinse off all foam and let the shaver run for a few more seconds.
•Next switch the shaver off and press the release buttons. Lift the shaver foil off and pull the cutter block out. Then leave the disassembled shaving parts to dry.
Alternatively, you may clean the shaver using the brush provided.
•Switch the shaver off. Press the release buttons and lift shaver foil off.
•Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.
4