Braun BS 8795 manual Description, Before shaving

Page 24

eco normal intensive

cartridge

full

 

empty

1

2

Description

1.Special cord set

2.«start cleaning» button

3.Station-to-shaver connecting contacts

4.Station lift button for cartridge exchange

5.Display for cleaning programs

6.Display for cleaning fluid status

7.Station mains socket

8.Cleaning cartridge

9.Shaver foil protection cap

10.Shaver foil

11.Cutter block

12.Foil release buttons

13.Long hair trimmer

14.Shaver-to-station connecting contacts (shaver backside)

15.Switch

16.Shaver display

17.Info key

18.Pilot light

19.Shaver mains socket

Before shaving

If you wish, you may start shaving right away (if the shaver is charged, see section «Shaver display»). However, we recommend to follow the procedure described here.

Using the special cord set (1), connect the mains socket of the Clean&Charge station (7) to the mains.

Press the station lift button (4) to open the housing.

Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).

Carefully remove the lid from the cartridge.

Slide the cartridge into the base of the station as far as it will go.

Slowly close the housing by pushing it down until it locks.

24

Image 24
Contents 8795 Page Stop Page Page Page Page Start Full Empty Clean eco normal intensive Page Page 8795 Old new Page Page Page Page Page Page Page Page English Description Before shavingWe recommend cleaning after each shave Shaving After shavingQuick cleaning Shaver displayAccessories Guarantee Environmental noticePage Page 643-455/01/XII-04