Braun 3535, 3533 manual English

Page 3

English

Carefully read the use instructions before use.

Important

Plug your hairdryer into analte- rnating current (~) outlet only and be sure that your household voltage corresponds to the voltage marked on the hairdryer.

Do not allow the ap-

 

pliance to become wet.

When using the hairdryer in a bathroom, always unplug it after use. Even a switched-off hairdryer presents a hazard if not unplugged.

For additional protection, it is advisable to install a residual current device (RCD) with a rated residual operating current not exceeding 30 mA in the electrical circuit of your bath-room. Ask your installer for advice.

Care should be taken not to block the inlet and outlet grill when the hairdryer is switched on. If either grill becomes blocked, the hair- dryer will automatically cut out. After cooling for a few minutes, it will switch back on automatically.

Do not wrap the mains cord around the appliance. Regularly check the mains cord for wear or damage, particularly where it enters the product and the plug. If you have any doubt about its condition take the appliance to your nearest Braun Service Centre for checking/repair.

The mains cord of the appliance may only be replaced by an authorized Braun Service Centre. Unqualified repair work can lead to extreme hazards for the user.

Switch 1 0 = off

1 = gentle drying

2 = fast drying

Cord storage 2

The cord can be stored conveniently in the handle.

Subject to change without notice.

Image 3
Contents Type 3533 Type 1000 English Guarantee