Emjoi AP-3MPR manual Keep the protective cover on your unit when it is not in use

Page 6

4.To turn On your unit, press the safety switch lock and at the same time slide it up to the desired speed.

0 Power "OFF"

1 Low speed

2 High speed

5.Turn on the unit (￿g. 4) and gently rotate (back and forth or side to side) over the callous/corn/hard skin area for 2-3 seconds. Do not press hard - gently glide the unit over desired area. The unit will stop if it is pressed too hard on the skin. Turn the unit o￿ and check if you achieved the softness you desire. If not, turn on the unit and go over the area for 2-3 seconds more and check again. Continue to use this method until the level of smoothness is obtained.

Warning: Stop using if skin becomes sore or in￿amed.

Warning: Do not use on skin for more than 2-3 seconds at a time.

4

5

6.Turn the unit o￿ (￿g. 5).

7.Rinse the skin or use a wet towel to get rid of the excess dead particles.

8.To clean the Emjoi®Micro-Pedi Pro Tornado, please see the Cleaning section.

9.Keep the protective cover on your unit when it is not in use.

P. 5

Image 6
Contents AP-3MPR General Description of Parts Page Page HOW to USE Keep the protective cover on your unit when it is not in use Changingthe MICRO-PEDI Protornado Roller Page Cleaning Do not place your unit in water or drop water into your unit Keep the protective cover on your unit when it is not in use Keep original receipt for warranty service