Philips AT921 manual English

Page 17

English 17

-- Clean the inside and outside of the shaving guard with the brush.

6Put the shaving heads back into the shaving unit.

Make sure that the projections of the shaving heads fit exactly into the recesses.

7Put the retaining frame back into the shaving unit and turn the lock clockwise.

8Insert the lug of the shaving unit into the slot in the top of the shaver (1).Then close the shaving unit (2).

Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked.

Cleaning the trimmer with the cleaning brush (AT940/AT921/AT893/AT890 only)

Clean the trimmer every time you have used it.

1Switch off the shaver.

2Push the trimmer slide downwards to open the trimmer.

3Clean the trimmer with the short-bristled side of the cleaning brush. Brush up and down along the trimmer teeth.

4Close the trimmer (‘ click’).

Image 17

Contents AT940, AT921, AT893, AT890, AT753 AT752, AT750 Page Page Page AT940,AT921,AT893,AT890,AT753,AT752,AT750 Introduction General description EnglishEnglish General Compliance with standardsCharging Charge indications Battery lowCharging Battery fully chargedQuick charging AT940/AT921/AT893/AT890 only Charging in the charging stand AT940/ AT921 only Using the shaverCharging with the adapter Wet shaving Shaving tips and tricksTrimming AT940/AT921/AT893/AT890 only Dry shavingCleaning and maintenance Cleaning the shaving unit under the tap Cleaning the shaving unit with the cleaning brush English Storage ReplacementShaving heads AccessoriesCleaning Environment Removing the rechargeable shaver batteryTroubleshooting Guarantee and serviceGuarantee restrictions Foam or gel Description générale IntroductionAvertissement Mise en gardeConformité aux normes Recharge GénéralitésInformations relatives à la charge Pile faible Chargement à l’aide de l’adaptateur RechargePile complètement chargée Trucs et astuces de rasage Utilisation du rasoirRasage humide Tonte modèles AT940,AT921 AT893 et AT890 seulement Rasage à secNettoyage de l’unité de rasage sous le robinet Nettoyage et entretienNettoyage de l’unité de rasage avec la brosse Détachez l’unité de rasage du rasoir Remettez les têtes du rasoir dans l’unité de rasage Rangement RemplacementAccessoires Nettoyage Têtes de rasageEnvironnement Pour retirer la pile rechargeable du rasoirRestrictions de garantie Garantie et servicesProblème Cause possible Solution Résolution de problèmesLe rasoir ne La pile Page Page Page Page 4222.002.5260.3