Philips 25LC, 35LC important safety instructions Comb, Natural direction, One Step Select Switch

5. BEFORE TRIMMING HAIR

6. TRIMMING YOUR HAIR

7. TRIMMING TOP OF HEAD

1.Be certain Hair Clipper is clean (free of hair and debris), properly lubricated and fully charged (see

MAINTENANCE).

NOTE: If cutter blades are run- ning slowly or do not move, they may be dirty and clogged. Clean and lubricate following MAINTENANCE instructions.

2.Seat person having hair trimmed so that the top of their head is at your eye level.

■Place towel around their neck.

3.Comb hair well to remove all tangles. It is not necessary to wash hair before trim- ming. For best results, use on dry hair.

4.For accurate cutting control, hold Hair Clipper in a com- fortable grip. This is impor- tant for a precise, even cut.

5.For best results, comb hair often during trim to be cer- tain the cut is even.

6.If using Hair Clipper for the first time, trim only a small amount of hair at a time, until you become comfortable with Hair Clipper and the One Step Select Switch.

IMPORTANT: When using Hair Clipper without Comb Attachment, use a slow, smooth motion to prevent trimming off more hair than desired.

1. Use Hair Clipper with Guide

Comb.

2. Comb hair so that it falls into its

natural direction.

3. Begin at highest setting (#7) on

One Step Select Switch.

■After you are familiar with the Hair Clipper, you may easily choose between the 7 settings for your desired length.

4.Hold Hair Clipper with Guide Comb flat against the scalp (Fig. 4).

5.Start at the sides of the head. Move Hair Clipper up slowly against direction of hair, lifting it up and outward through hair, cutting a small amount at a time.

6.Continue trimming at neck and back of head (Fig. 5).

7.If you want hair shorter, change One Step Select Switch to a lower setting and follow same steps.

1.Use Guide Comb Attachment at lowest setting (# 1) or remove it entirely.

2.Comb hair forward over eyes.

3.Using barber comb, lift a small section of hair at a time and grasp hair between two fingers.

■The amount of hair you wish to cut should extend beyond your fingers (Fig. 6).

4.Trim and blend hair using scissors or Hair Clipper at lowest setting.

5.Continue this procedure, working from the front to the back of head.

■As you work to the back, you may gradually cut hair shorter by holding fingers closer to head when grasp- ing sections of hair.

6.Comb hair often to remove trimmed hair and to check for uneven areas.

4 5

6