6.
4Brush the inside of housing and Razor Head Assembly.
5Replace the Razor Head Assembly back on razor.
Every Two Months:Razor Heads
1Turn razor OFF and disconnect from outlet.
2Remove Razor Head Assembly off housing unit.
3Brush the inside of the housing.
4Turn Razor Head Assembly over so that the underside is exposed.
5Press down and turn wheel of frame counterclockwise.
6Remove the frame and brush clean.
7Remove and clean one cutter and head at a time.
•Be careful not to mix up cutters and heads.They are a matched set and if interchanged,it will greatly affect shaving performance.
7.
8Separate the cutter from the comb.
9Only brush the cutter in an upward motion. Use the short bristled side of the brush.
10Brush the slots of the razor head.
For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g.Norelco Razor Cleaner or alcohol) and lubricated with Norelco Razor Lubricant,model AL80,or one drop of mineral oil (in the center of the head).
11Replace the cutter and razor head in the Head Assembly.
12Repeat the process for the other two razor heads (cutters and combs).
13Replace the frame.
14Press down and turn the wheel clockwise until it locks into place.
15Replace the Razor Head Assembly back on razor.