Philips 6424LC, 6423LC manual Brush the slots of the comb, Down, Philips Norelco Service Location

14ENGLISH

ENGLISH 15

4 Turn Razor Head Assembly over so that underside is exposed.

C 5 Turn wheel of frame counterclockwise.

6 Remove the frame and brush clean.

C 7 Remove and clean one cutter and comb at a time.

Do not clean more than one cutter and comb at a time, since they are all matching sets. If you

13

C 14

C 15

16

Replace the frame.

Turn the wheel clockwise until it locks into place.

Replace the Razor HeadAssembly back on razor.

Put the protective razor head cap on the razor to protect heads.

accidentally interchange the cutters and combs, it

could take several weeks before optimal shaving

performance is restored.

8 Separate the cutter from the comb.

C 9 Only brush the cutter in an upward motion. Use the short bristled side of the brush.

C 10 Brush the slots of the comb.

For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Philips Norelco Razor Head Cleaner, model

RC1776 or alcohol) and lubricated with Philips Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head). This helps prevent wear of the shaving heads.

C 11 Replace the cutter and comb into the Razor Head Assembly.

12Repeat the process for the other two sets of cutters and combs.

After Each Use:Trimmer

		1	Turn razor to OFF (O) position.
C			Push trimmer slide switch up to pop up
		2
	C		trimmer.
			Clean trimmer with the brush every time
		3
			you use it.

C 4	Lubricate the trimmer teeth with Philips
	Norelco Razor Lubricant (model AL80) or
	with one drop of mineral oil every 6 months.
5	Close trimmer by sliding trimmerswitch
	down.
This razor has no other user-serviceable parts.
Any other service should be performed by the
Philips Norelco Service Location.