Philips Y5524 Using the beard styler attachment with comb, You can now start styling your beard

Page 12

12ENGLISH

Using the beard styler attachment with comb

You can use the beard styler attachment with the

comb attached to trim your beard at one fixed

setting, but also at different length settings.The hair length settings on the beard styler attachment correspond to the remaining hair length of your beard after cutting.You can choose any setting between 1 and 4.5mm.

1 Press the length selector (1) and then push it to the left or right (2) to select the desired hair length setting.

2 Press the on/off button to switch on the appliance.

3 You can now start styling your beard.

Make sure that the front of the comb is fully in contact with the skin, and move the appliance against the direction of hairgrowth.You may want to try different position, upwards, downwards, or across depending on the direction of hairgrowth.

Image 12

Contents Always Here to Help YOU Page Table of Content Introduction Make sure the adapter does not get wetEnglish Compliance with standardsGeneral General DescriptionDisplay ’Charging’ indication’Battery fully charged’ indication  ’Battery low’ indicationCharging ChargingUsing the Shaver Quick chargeBody hair or scalp hair Attaching the shaving attachmentPress the on/off button to switch off the appliance Shaving Skin adaptation periodWet shaving Or shaving gel off the shaving unit see also chapter Hair differs from body hair or scalp hairAttaching the beard styler attachment Using the beard styler attachment with comb You can now start styling your beardUsing the beard styler attachment without comb Pull the comb off the accessoryStyling tips Beard stylesSide burns No beard at all Attaching the bodygroomer attachment Attaching the trimming comb TrimmingMove the appliance against the direction of hair growth GroomingCleaning and Maintenance Trimming and grooming tipsCloth Cleaning the shaving unit Reattach the shaving unit to the shaving attachmentExtra-thorough cleaning method Clean the cutter with the cleaning brush suppliedReattach the shaving unit to the shaving attachment Cleaning the bodygroomer attachment Cleaning the styler attachmentReplacement StorageLift the retaining ring out of the shaving unit Ordering Accessories YS511 Philips beard styler attachmentEnvironment Remove the rechargeable battery EnglishGuarantee and Service Guarantee restrictionsTroubleshooting Long hairs obstruct Clean the cutters Shaving heads This appliance is notBrush supplied. See ChapterRechargeable battery When you removeAdapter from the wall From the appliance Appliance does not work For a few seconds My skin isRecharge the battery. See chapter Rotation Too much dirt hasSpeed Collected in the shaving See chapter Heads Is lower than UsualReduced You use the appliance Comb properly If you are trimming very4222.002.5433.1